Transmission screen data of the USB cable, PC (Type-A USB) to the man-machine interface USB (Mini-B).For the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 1 meters.Adapter for EX module (5 / set)For connecting GP operation data with RS-422 and power /DIO terminals Proface GP070-AT01. For thin film surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set)Protection for GP rear connectors (large and small for each of the 1) GP070-AT01Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).One end is a loose wire, which is used to carry out RS-232C connection between the host and LT.I/O module, including 32 point NPN/PNP inputUsed to install the human machine interface to the fixed panel (2 / cover) Proface GP070-AT01. 5.7 inches, replace the backlight (1 / set)Screen protection cover (1 pieces) for protecting screen against pollution of man-machine interfaceUsed to install the GP3000H series to a commercially available support arm or panel.Replaceable anti fouling film for protecting screen protective film (5 sheets / cover) Proface GP070-AT01. Backup battery for time and data backup (1).The host controller is connected to the host computer interface, which is used for multiple connection (n:1) communication.Suitable for A/B+ Type modelsGP4000 series back mounted model of waterproof rubber gasket Proface Mounting screw. (1)Standard cable for connecting GP3000H adapter and GP3000H.
Length: 3 meters. Adapter for EX module (5 / set)Mounting screws (4 sets) to be fitted to the hard panel at the interface of the machine Proface Mounting screw. Used to output the image signal from the host computer to GP7.4 inches or larger, for external reset input, NETWORK FLEX communication, audio output. AUX connector, L typeScreen protection cover (1 pieces) for protecting screen against pollution of man-maachine interfaceUsed to prevent accidental operation Proface Mounting screw GP070-AT01. Includes 3 mounting screws.COM2 interface with the cable (RS-422), used to connect the 2-Port adapter to the man-machine interfaceB/B+/C FLEX NETWORK Type connector (5)Cablle for connecting GP3000 to various modulesWhen the man-machine interface is installed to the hard panel to provide dust and moisture proof function (1)