"2 axes, SSCNET III type.
2 axis linear interpolation.
2 axis arc interpolation.
Control unit: mm, inch, degree, pulse.
Location data: 600 data / axis.
40 pin connector.
Through the SSCNET III cable connection to save wiring, the distance between the station up to 50m.
Absolute position system for determining the origin position is supported by the return data set operation MITSUBISHI Q02PHCPU PDF catalog Q02PHCPU
In addition, the limit switch of the upper limit, the lower limit switch and the near point block signal input can be directly connected to the servo amplifier,
Thus greatly reducing the wiring requirements.
Easy to achieve high speed, high precision positioning control.
Support for multiple types of positioning control,
Including 2 ~ 4 axis 2 axis linear interpolation, circular interpolation, speed control and speed / position control, path switching control, constant speed control etc MITSUBISHI Q02PHCPU PDF catalog. .
In addition, can use the "Configurator-QP GX" and other software,
Easy to set, monitor and debug. "1 channels.
Input (weighing sensor output): V/V 0.0~3.3m.
Output (resolution): 0~10000.
Conversion speed: 10ms.
18 point terminal MITSUBISHI Q02PHCPU PDF catalog.
Weighing sensor input module capable of directly connecting with all kinds of weighing sensor.
The weighing sensor can now be directly connected to a programmable controller system,
Without the need for an external connection to the signal converter, etc..
By ensuring the accuracy of the weighing sensor, stable data conversion speed,
To achieve a high precision measurement.
No external signal converter!
The weighing sensor input module is directly connected to the programmable controller, which can reduce the time and cost of the sensor!
Various types of weighing sensors can be connected with the magnetostrictive type, capacitive type, rotary instrument or strain gauge.
Can connect 6 wire system (combined with remote sensing technology and ratio method) or 4 wire system weighing sensor. Input / output points: 4096 points.
You can use the CF card.
Version OS:VxWorks 5.4.
Easy connection programming tool via ethernet.
Programming tools (Works2 GX, Developer GX) and CPU direct connection (1 to 1),
No need to carry out the IP address settings. And there is no need to select the cable, the straight line and the cross line can be used.
Therefore, this connection method and the use of USB, can easily communicate with the CPU,
Even the operators are not familiar with the network settings can easily establish a connection.
Easy connection through the hub CPU.
By using an Ethernet hub, programming tools and multiple CPU can be connected simultaneously.
Through the programming tool can be searched and displayed in the list has been connected to the CPU.
Therefore, even if the IP CPU address is unknown, just choose from this list, you can easily connect.
Seamless communication without network level constraints.
With the latest high-speed, large capacity IE CC-Link controller network annd IE CC-Link field network,
Corresponding to the increasing amount of information Q02PHCPU PDF datasheet.
Together with previous MELSECNET/H, Ethernet and CC-Link,
These networks can be across the network type or level of differences, to achieve seeamless communication Q02PHCPU PDF datasheet.
Programmable logic controller on the network through the programming tool of the Ethernet connection,
Monitoring and programming.