MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 45KW.
When the ring is opened, the frequency converter is provided with a load of the motor when the motor is operated with a load at a given frequency,
The range of the motor speed in the rated slip ratio (1%~5%) changes FX2NC-96MT-D/UL Manual.
For the requirements of relatively high precision, even if the load changes are also required to operate at a given speed of the occasion,
Inverter with PG feedback function can be used (selection) FX2NC-96MT-D/UL
If the given acceleration time is too short, the output frequency of the inverter is far more than the change of the speed (electric angular frequency),
Converter will be due to flow over the current trip, the operation stopped, which is called stall FX2NC-96MT-D/UL Manual. Cable flat cable;
Connector with 20 pin installed at both ends of the fuse.
Length 1.5M. Cable length: 2m.
RS-485 terminal unit conversion unit.
Applicable model: GT16. The largest input / output points: 30 points.
Power supply voltage: 24VDC.
Input points: 16 points.
Output points: 14 points.
Output type: Transistor (source) FX2NC-96MT-D/UL Manual.
Power consumption (W): 8.
Weight (kg):0.35.
Size (WxHxD) mm:100x90x49.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator MITSUBISHI FX2NC-96MT-D/UL HARDWARE MANUAL.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0 MITSUBISHI FX2NC-96MT-D/UL HARDWARE MANUAL.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment MITSUBISHI FX2NC-96MT-D/UL HARDWARE MANUAL. Power: 1.5kw.
Voltage: 200V.
Purpose: high frequency braking resistor.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor.
Can also be connected without built-in brake transistor inverter FX2NC-96MT-D/UL .
Three types of discharge resistors are available.
Please select according to the required braking torque. Application: a write device (with a built-in flash memory) that is not requuired to use a similar ROM writer,
GOT can be carried out between the fast and simple picture data transmission FX2NC-96MT-D/UL Manual.
Application Series: F940WGOT, F940GOT.