Cable length: 20m.
For QnA/ACPU/ motion controller CPU (A Series) /FXCPU. Connection between (D-SUB25 pin connector) and GOT.
For the connection between FA-CNV*CBL and GOT.
Connector for serial communication unit and GOT.
For the connection between AJ65BT-G4-S3 and GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21 MITSUBISHI touch screen User's Manual. Used to prevent accidental shutdown switch GT2512-STBA-GF
Applicable model: hand held GOT. Cable length: 20m.
For long distance connections between QCPU and GOT (above 13.2M) (need A9GT-QCNB).
Long distance connection between two GOT.
Applicable models: GT16, GT15, GT11, GT27, GT25. Protective film for 12.1 inch screen.
Transparent, 5.
Applicable model: GT15. Protective film for 4 MITSUBISHI touch screen User's Manual. 7 inch screen.
Transparent (frame: white), 5.
Applicable model: GT104. Protective film for 5.7 inch screen.
Transparent, 5.
Applicable model: GT105. Cable length: 5.0m.
For QnA/ACPU/ motion controller CPU (A series, extended basis system) and the connection between GOT.
Applicable models: GT16, GT15, GT11. Protective film for 3.7 inch screen.
Scrub (frame: white), 5.
Applicable model: GT1020 MITSUBISHI touch screen User's Manual. 10.4 inches.
Surface treatment: transparent.
Protective film color: No.
USB protective cover parts: no openings.
Set number: 5.
Applicable model: GT21. For the GT1595-XTB.
Applicable model: GT16 GT2512-STBA-GF User's Manual. Cable length: 15m.
For long distance connections between QCPU and GOT (above 13.2M) (need A9GT-QCNB).
Long distance connection between two GOT GT2512-STBA-GF User's Manual.
Applicable models: GT16, GT15, GT11, GT27, GT25. Cable length: 1.2m.
For motion controller CPU (A series, the main base system) and the connection between GOT.
Applicable models: GT16, GT15, GT11. With 4.3 inch widescreen.
Surface treatment: anti reflective film.
Protective film color: No.
USB protective cover parts: no openings GT2512-STBA-GF User's Manual.
Set number: 5.
Applicable model: GT21. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 8.4 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: VGA (640 x 480).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touuch screen system GT2512-STBA-GF Manual .
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MITSUBISHI touch screen User's Manual.