Cable length: 1 meters.
FXCPU GOT.
FXCPU communication function expansion board GOT.
[MINI-DIN 8 pin loose line (row 5 pin interface terminal)].
Applicable model: GT21. Cable length: 3m.
The connection between the FXCPU communication function extension board (D-SUB9 pin connector) and the GOT/ personal computer (D-SUB9) (GTSoftGOT100 pin) MITSUBISHI touch screen User's Manual.
The connection between the FXCPU communication function adapter (D-SUB9 pin connector) and the GOT GT2708-STBA-GF
For personal computer (screen design software) (D-SUB9 pin, the mother''s head) and GOT (D-SUB9 needle, the mother of the head) of the connection between.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21. With 4.3 inch widescreen MITSUBISHI touch screen User's Manual.
Surface treatment: transparent.
Protective film color: No.
USB protective cover parts: no openings.
Set number: 5.
Applicable model: GT21. Bus connection (2 channel) unit standard model for QnA/ACPU/ transport controller CPU (A series).
Applicable models: GT15, GT16. Series: multimedia and advanced features and features of a variety of high-performance models.
Screen size: 8.4 inches.
Display color: 256 color or more color MITSUBISHI touch screen User's Manual.
Installation type: compatible with multimedia and video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black GT2708-STBA-GF User's Manual.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
High performance models with multimedia and advanced features and functionality (including embedded communications capabilities) GT2708-STBA-GF User's Manual.
User storage capacity: 15MB (GT16__-VNB__:11MB).
With HOST USB and device USB port.
Standard Ethernet, RS-422/485 and RS-232 ports.
Support multimedia and video /RGB units.
Analog touch panel.
Do not let the touch screen surface with water drops or other soft things stick to the surface,
Otherwise, the touch screen is easy to mistake that there is a hand touch caused by surface acoustic wave screen is not allowed GT2708-STBA-GF User's Manual.
In addition to cleaning the dirt on the surface of the touch screen,
You can use a soft dry cloth or a cleaning agent to clean out the center of the screen carefully,
Or use a dry soft cloth dipped in industrial alcohol or glass cleaning fluid to clean the touch screen surface.
Touch screen response is slow if you use a hand or other touch to touch the surface acoustic wave touch screen,
This shows that it is likely that the touch screen system has been obsolete, the internal clock frequency is too low,
Or because there is water in the surface of the touch screen to make the touch screen mobile, rapid response recovery,
To replace or upgrade the system must, or use dry cloth touch sscreen on the surface of the water GT2708-STBA-GF Manual .
If the user is operating the touch screen, the direction of the touch move is to the left,
But the cursor of the system moves to the right,
The failure may be due to the conneection of the control box and the touch screen connected to the connector or the touch screen,
Users as long as the direction of the re exchange of it MITSUBISHI touch screen User's Manual.