For 5.7 inch models, for the 5.7 inch man-machine interface into the LT series (A/B/B+/C/H Type) of the opening.10.4 inches (TFT), the replacement of the host backlight (1).10.4 inches (STN), the replacement of the host backlight (2 / set).Portable GP2000H series models accessories, RS-232 single head cable (3 m) Proface ZC9USCL1. COM 2 interface with the cable, for the conversion of the D-Sub 9 pin concave joint to the D-Sub 25 pin convex connectorInput / output hybrid I/O modules, including 32 point NPN/PNP input and 32 point NPN transistor output512MB, for the implementation of the picture save, log and data backup and other data management operations, such as compression flash memory card ZC9USCL1Adapter for EX module (5 / set)The module is used for mounting on the back board of the GLC2000 series host computer Proface ZC9USCL1. Then you can install the GP77R series or GLC100 series of medium size expansion module in the module on the outward side.Used to connect the GP2000H series RS-422 conversion adapter with GP3000H, with D-Sub connectors.
Length: 10 meters. A connector that connects the DIO interface for connecting an external I/O device (5 sets) Proface ZC9USCL1. For the direct connection of the MITSUBISHI FX series CPU PLC (not to be used at the same time, the programmer) length: 1 meters.AUX connector for external output (5 / set).Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).Expansion module for the GP3000 access to the CC-Link network and communication with the CC-Link master station (support for intelligent devices)Touch screen anti ultraviolet protective film (1 pieces) Proface USB cable fastener (Type-A) (1 interface) Proface USB cable fastener (Type-A) (1 interface). The three color tower lamp installed on the fixed panel is connected with the human machine interface through the USB interface.10.4 inch TFT models applicable parts, for the 10.4 inch man machine interface (TFT) into the 10.4 inch GP2500 (TFT) in the installation of the required accessories Prroface USB cable fastener (Type-A) (1 interface) ZC9USCL1. Mounting screws (4 sets) to be fitted to the hard panel at the interface of the machine.Used to connect the 2-Port adapter to GP4000Used to install the human machine interface to thee fixed panel (2 / cover) Proface ZC9USCL1. Video-Mix module (32000 color, video input x 4 channel, analog RGB input x 1 channel, analog RGB output x 1 channel, VGA/SVGA)