Used to convert RGB to DVI-ACable for transmitting an image signal from an Pro-face host to a Pro-face industrial display or other commercial display device (24- DVI-D pin convex).GP-230/250/270 series is replaced by ST series, the gap filled with the opening of the panelInterface module for the simultaneous use of A/QnA/FX series external controllerLT4000M (module type DIO), PNP output, DC24V (host) Proface ST400-DF01 ST400-DF01 The main controller is directly connected to the man-machine interface (D-sub 9 pin concave) for multiple connection (n:1) communication.13 pin input connectors for HTB and 16 pin output connectors. (1 / set)For multi connection communication, length: 5 meters.Converting 4 analog signals into digital signalsDisposable film (5 sheets / sets) for protecting screen against contamination of human computer interfaceUsed in a variety of host and man-machine interface for RS-232C connectionThe main controller is connected to the man-machine interface for MPI communicationThe host controller is connected to the host computer interface, which is used for multiple connection (n:1) communication Proface ST400-DF01 Proface ST400-DF01. COM1 interface with the cable for direct connection to the CPU series PLC AUsed to install the GP3000H series to a commercially available support arm or panel.LT4000M (module type analog), PNP output, DC24V (host).1-0 DVI standard (DVI-D 24 pin convex connector)Transmission screen data, such as the USB cable, PC (Type-A USB) to the man-machine interface USB (Type-A)Used to connect the 2-Port adapter to GP4000Use external output for the GP3000 series of auxiliary connectors (5 / sets) Proface Screen protection film Proface Screen protection film. When the man-machine interface is installed to the fixed panel for providing dust proof and moisture proof function (1 pieces).7.4 inches or larger, FLEX NETWORK GLC2300 connector (5 groups)For 5.7 inch models, for the 5 Proface Screen protection film. 7 inch man-machine interface into the LT series (A/B/B+/C/H Type) of the opening.7.4 inches, replace thhe backlight (1 / set)The main controller is connected to the host computer interface (can be switched between RS-232C and RS-422) using the isolation module ST400-DF01. NETWORK FLEX 64 point DIO connector terminal block, (including 2)15 pin I/O joint (joint Ax1, joint Bx1) and 6 pin I/O connector (joint Cx 1, connector Dx1) Proface ST400-DF01. Note: joints A and B are different, the joints C and D different.