5 / setsI/O expansion module, including the 8 point relay /1 public end15 pin I/O joint (joint Ax1, joint Bx1) and 6 pin I/O connector (joint Cx 1, connector Dx1). Note: joints A and B are different, the joints C and D different.Converting 2 analog signals into digital signalsCOM1 interface with the cable (RS-232C), used to connect directly to the CPU series PLC FX (not the same time using the programming controller)When the man-machine interface is installed to the fixed panel to provide dust proof and moisture proof function Proface PFXZGMNT1 PFXZGMNT1 (1)12.1 inches, replace the backlight (1 / set)USB cable to prevent disconnection of the fastening clip (5 / set)To prevent the connection of disconnected USB cable fastening clips (Mini-B USB, 1 interface, 5 / set)Colorful LED switch with USB interface Proface PFXZGMNT1. Connector for connecting DC power cord. (linear, 5 / set)COM1 interface with the cable for direct connection to the CPU series PLC AUsed to interface the main machine output serial port (D-sub 9 pin concave type) directly connected to the RS-422 terminal block.7.4 inches, installed to provide the function of dust and moistureLT fasteners installed on the control panel (4 / set)13 pin input connectors for HTB and 16 pin output connectors Proface PFXZGMNT1. (1 / set)For 5.7 inch models, for the 5.7 inch man-machine interface into the LT series (A/B/B+/C/H Type) of the opening.With the installation of screws (4 / sets), for the GP4000 series back mounted to the fixed panel models Proface The display module mounting nut. (2 / set)Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00) Proface The display module mounting nut. Stop pin, prevent cable connection loose USB cable fastening clip (Type-A*1 USB, Mini-B, each 1 interface), used to adjust the thickness of the mounting panel 2mm gasket (1 pieces).15 inches, GP installed to the hard panel to provide dust and moisture proof function Proface The display module mounting nut. 7.4 inches, replace the backlight (1 / set)DDisposable film (5 sheets / sets) for protecting screen against contamination of human computer interface PFXZGMNT1. Disposable battery (1 blocks) for backing up clock data.Expansion module for the GP3000 access to the CC-Link network and commmunication with the CC-Link master station (support for intelligent devices)Used to install the human machine interface to the fixed panel (2 / cover) Proface PFXZGMNT1.