RS-422/485 serial communication unit (terminal unit).
When the temperature controller is connected to the temperature controller through the RS-485 or the GOT multi point connection, the controller can be used.
Applicable models: GT15, GT16, GT27, GT25. Cable length: 20 meters.
PC to GOT long distance connection cable MITSUBISHI GT15-BAT.
For connection between GOT and GOT. Oil resistant cap for 15 inch screen GT15-BAT
Applicable model: GT16. Cable length: 13m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT. Cable length: 5m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT. Cable length: 3m.
The connection between the CC-LINK interface unit and the smart GOT MITSUBISHI GT15-BAT.
Applicable model: HandyGOT. Life is 40000 hours, and the user can simply change the background light.
Application Series: F943GOT. Cable length: 5.0m.
For the connection between QnAS/AnSCPU/ motion controller A7GT-CNB (A Series) and CPU.
Applicable models: GT16, GT15, GT11. A series of high performance models that are widely used in network or single machine work environments MITSUBISHI GT15-BAT.
Screen size: 12.1 inches.
Display color: 256 color or more color.
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black MITSUBISHI Stop switch guide.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment MITSUBISHI Stop switch guide.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen syystem MITSUBISHI Stop switch guide GT15-BAT.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MITSUBISHI GT15-BAT.