LK Automation Limited LK Automation Limited
Brand: OMRON | MITSUBISHI | Proface | Mennekes | Yaskawa
Go Back >> Product Catalogues
GT15-80PSGW Scrub (frame: white), 5 MITSUBISHI GT15-80PSGW Optional function board
Brand: MITSUBISHI
Name: Resist film
Model: GT15-80PSGW
Protective film for 12.1 inch screen.
Scrub (frame: white), 5.
Applicable model: GT15.

Cable length: 3.0m.
For the connection between QCPU and GOT.
For connection between two GOT.
Applicable models: GT16, GT15, GT11, GT27, GT25. Protective film for 12.1 inch screen.
Scrub, 5.
Applicable model: GT16. 48MB extended memory.
Applicable model: GT15. Application: installed on the surface of the panel or the use of L type mounting bracket,
So you can use a dedicated cable,
F9GT-HCAB-__M easily connect the hand-held GOT and RS-422 ports to connect / disconnect MITSUBISHI GT15-80PSGW GT15-80PSGW
Attachment: L type mounting bracket.
Application Series: hand held GOT (RH type). For analog RGB input 2CH (1ch individual display).
Applicable model: GT27. Protective film for 4.7 inch screen.
Scrub, 5.
Applicable model: GT104 MITSUBISHI GT15-80PSGW. QCPU (Q mode) bus connection.
1 joint.
Applicable models: A985 (-V) /975/970/960GOT. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 5.7 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: QVGA (320 x 240).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black MITSUBISHI GT15-80PSGW.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit MITSUBISHI Optional function board.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system MITSUBISHI Optional function board.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system softwware,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MITSUBISHI Optioonal function board MITSUBISHI GT15-80PSGW GT15-80PSGW. For QCPU (Q) / transport controller CPU (Q Series) the bus (2 channel) thin type unit.
Applicable models: GT15, GT16, GT27, GT25.


...More relevant models >>>>
Last one: GT15-80PSCW
next one: GT16-70PSCB