15 pin I/O joint (joint Ax1, joint Bx1) and 6 pin I/O connector (joint Cx 1, connector Dx1). Note: joints A and B are different, the joints C and D different.For 5.7 inch models, for fixing the hooks of the three EX modules.Length: 5 meters.Connect to the SIEMENS PLC or MPI, used to connect the commercial type PROFIBUS connector COM2Portable GP2000H series models accessories, RS-232 single head cable (3 m) Proface CA7-CBLCVRGB-01 CA7-CBLCVRGB-01 Suitable for A/B+ Type modelsFor the direct connection of the MITSUBISHI A series CPU PLC (not to be used at the same time, the programmer) length: 5 meters.For thin film surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set)3.5 inch screen protective cover (1 pieces)COM2 module is applicable for the isolation of COM2 through a variety of hosts and GP3000 connection7 inch widescreen display module installed on the senior panel adapter GP-2400, GP-3400 and GP-4400 series of holes Proface CA7-CBLCVRGB-01. Used to connect the GP2000H series RS-232C conversion adapter with GP3000H, with D-Sub connectors.
Length: 3 meters. Connector for connecting DC power cord Proface CA7-CBLCVRGB-01. (right angle, 5 / set)12.1 inch /10.4 inch (STN), thin film for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set).LT4000M (module type DIO), NPN output, DC24V (host).The main controller is connected to the man-machine interface for MPI communicationUsed to connect the SIEMENS S5 PLC series to the host computer interfaceDisposable film (5 sheets / sets) for protecting screen against contamination of human computer interface Proface DVI-RGB conversion cable Proface DVI-RGB conversion cable. Expansion module for the GP3000 access to the PROFIBUS network and DP PROFIBUS master communicationConnect to USB printer (Type-B).The man-machine interface directly connected MITSUBISHI electric PLC Q series CPU programming port Proface DVI-RGB conversion cable. Used for surface protection of man-machine interface from oil and chemmical pollution (5 / set) CA7-CBLCVRGB-01. Standard cable for connecting GP3000H adapter and GP3000H.
Length: 10 meters. Connector for connecting DC power cord. (linear, 5 / set)COM 2 interface with the cable, for the conversion of the D-Sub 9 pin concave joint to the D-Sub 25 pin convex connectorOne end is a loose wire, which is used to carry out RS-232C connection between the host and LT Proface CA7-CBLCVRGB-01.