10.4 inches (TFT), the replacement of the host backlight (1).Used to convert the USB interface to the serial interface (RS-232C). A modem or bar code reader that can be connected to support RS-232C.Expansion module for the GP3000 access to the PROFIBUS network and DP PROFIBUS master communicationTouch screen anti ultraviolet protective film (1 pieces) Proface CA6-EXMCNHE20P-01. 7.4 inches or larger, for external reset input, NETWORK FLEX communication, audio output CA6-EXMCNHE20P-01 AUX connector, L typeCOM1 interface with the cable (RS-232C), used to connect directly to the SYSMAC connection module (or other host)For multi connection communication, length: 5 meters.Touch screen anti ultraviolet protective film (1 pieces).When the man-machine interface is installed to the fixed panel for providing dust proof and moisture proof function (1 pieces) Proface CA6-EXMCNHE20P-01. Connector for connecting DC power cord (5)A1/A2/B+ DIO Type connector (compression type) (5 / set)Suitable for A/B+ Type modelsFor the operation screen (5 pieces) (GP3000H standard).I/O expansion module, including the 8 point relay /1 public endThe MITSUBISHI A series PLC is connected to GP, length: 5 m Proface CA6-EXMCNHE20P-01. Length: 5 meters.Cable for transmitting an image signal from an Pro-face host to a Pro-face industrial display or other commercial display device (24- DVI-D pin convex).For the man-machine interface hanging in the neck lanyard.To prevent the connection of disconnected USB cable fastening clips (Mini-B USB, 1 interface, 5 / set)5 Proface MIL connector (20 pin) for EX module. 7 inches thin film used for surface protection of man-machine interface from fingerprints, water droplets, dust and oil pollution (5 / set) Proface MIL connector (20 pin) for EX module. Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).Applicable to GLC-2600/2500, the need for bus converter (PSL-CONV00).For 5.7 inch models, for the 5.7 inch man-machine interface into the LT series (A/B/B+/C/H Type) of the opening Proface MIL connector (20 pin) for EX modulle CA6-EXMCNHE20P-01. The man-machine interface directly connected MITSUBISHI electric PLC Q series CPU programming port.Portable GP2000H series models accessories, RS-422 cable with D-Sub connector (10 meters).Stop pin, prevent cable connecction loose USB cable fastening clip (Type-A*1 USB, Mini-B, each 1 interface), used to adjust the thickness of the mounting panel 2mm gasket (1 pieces) Proface CA6-EXMCNHE20P-01.