Ratings: 1 A at 125 VAC.
LED indicator: With indicator.
Actuator: Plastic rod.
Many Models Including Roller Lever.
Switches are Only 16-mm Thick with Connector.
New center roller lever models that enable ganged mounting.
of up to 6 Switches.
Cable connectors for easy Switch replacement.
Triple-seal construction to provide IEC IP67 degree of protection OMRON A22L-CW-T1-01A.
Operation indicators available for easy monitoring,
(standard indicator is lit when Switch is not operating) A22L-CW-T1-01A
Approved by UL and CSA.
(Ask your OMRON representative for Information on approved models.) Type: winged.
Drive shaft type: semi cylindrical plug type.
Outlet hole: side 2.
Even number: 2.
Rubber material: NBR.
Head and body integration, strength and sealing performance is better, mechanical life is also significantly increased (5 million times) OMRON A22L-CW-T1-01A.
The most suitable for a variety of machine tools, automatic production line of the order control.
With drain holes, oil and water can be discharged after immersion. Actuator: Coil spring (spring diameter: 6.5).
Airtight.
Select the Best Two-circuit Switch for the,
Operating Environment and Application,
from a Wide Range of Models,
A wide selection of models is available, including General-purpose,
Environment-resistant, and Spatter prevention Switches OMRON A22L-CW-T1-01A.
Standard-feature gold-clad crossbar contacts provide high reliability OMRON Pushbutton Switch.
Applicable to either standard loads or microloads.
Switches with Lever Actuators provide 90° overtravel,
one-side operation, and four-direction head mounting OMRON Pushbutton Switch.
Approved standards: EN/IEC, UL, cUL, and CCC.
Contact your OMRON representative for information on approved models. Appearance: Round/Half-guard type LED lighting,
(without Voltage Reduction Unit) A22L-H.
Output: SPST-NO + SPST-NO.
Lighting: LED OMRON Pushbutton Switch.
Operating voltage: 24 VAC/VDC.
Operation: Momentary operation (self-resetting).
Illumination color: R (red); Y (yellow); G (green); W (white); A (blue).
Install in 22-dia. or 25-dia. Panel Cutout.
(When Using a Ring).
Lever for easily mounting and removinng the Switch Unit A22L-CW-T1-01A.
Increase wiring efficiency with three-row mounting of Switch Blocks.
Finger protection mechanism on Switch Unit provided as a standard feature.
Use 25-dia. ring to install in 25-dia. panel cutouts.
Mounteed using either open-type (fork-type) or closed-type OMRON A22L-CW-T1-01A.
(round-type) crimp terminals.
IP65 oil resistance (non-lighted models).
IP65 (lighted models).