Product Name:Connector PowerTOP® Xtra
Part No.:14209.
Ampere:63A.
Poles:4p
Voltage:>50-500V.
Earth position:2h.
Hertz >300-500Hz.
Connection technology:Screw terminals, SoftCONTACT.
Contact: highly heat resistant contact carrier MENNEKES 432.
Protection type IP67.
screw terminals 432
with rubberised grip area.
frame terminals.
with SoftCONTACT.
with highly heat resistant contact carrier.
cable gland and sealing.
strain relief and protection against kinking.
enclosure with thread lock.
two safety slides.
products with pilot contact: part no MENNEKES 432. + index P.Product Name:Wall mounted inlet
Part No.:346.
Ampere:32A.
Poles:4p.
Voltage:110V.
Earth position:4h.
Hertz 50-60Hz.
Connection technology:Screw terminals.
Contact:standard.
Protection type IP44.
screw terminals MENNEKES 432.
cable entry also possible on the back side.
enclosure base with stamped recess for quick cutting out.Connecting terminal with screw.
Terminal with tunnel.
High temperature resistant inner core.
The surface of the bolt body, plating.
Cable fastener.
Seal parts MENNEKES Panel mounted inlet.
With stress release device to prevent the cable from breaking.
Case with screw locking device.
Current: 125A.
Pole number: 4p.
Voltage: 400V MENNEKES Panel mounted inlet.
Location: 6h hour.
Hz: 50-60Hz.
Connection mode: screw connection.
Contact: nickel plated copper parts, high temperature resistant inner core.
Protection level: IP67.Product Name:Phase inverter plug AM-TOP®
Part No.:327.
Ampere:32A.
Poles:5p
Voltage:230V.
Earth position:9h.
Hertz 50-60Hz MENNEKES Panel mounted inlet.
Connection technology:Screw terminals.
Contact:standard.
Protection type IP67.
screw terminals.
single part body.
cable gland and sealing.
strain relief and protection against kinking.Product Name:Panel mounted inlet
Part No.:812.
Ampere:16A.
Poles:3p
Voltage:230V.
Earth position:6h.
Hertz 50-600Hz 432.
Connection technology:Screw terminals.
Contact:standard.
Protection type IP44.
screw terminals.
nicckel-plated contacts MENNEKES 432.
a retaining nose to hold the hinged lid of the connector must be provided by the customer in order to ensure satisfactory locking.