New DIN Track Mounting Temperature.
Controller.
Two channels of temperature control available despite width of,
only 22.5 mm.
The Temperature Controller itself can be replaced without,
changing terminal wiring.
Use in combination with a compact Setting Display Unit to,
reduce communications programming requirements E3Z-LT81-D 2M.
Front-panel LED indicators for easy operation monitoring.
Power supply and communications wiring not required between,
Units when mounted side-by-side E3Z-LT81-D 2M
CompoWay/F communications protocol supported.
UL, CSA, and CE Marking compliance. Size: 48 * 48mm, terminal type.
Category: control output 2 point type (power supply AC100 ~ 240V) E3Z-LT81-D 2M.
Shell color: black.
Control output 1: voltage output (SSR driver) .
Control output 2: voltage output (SSR driver).
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
Heater break, SSR fault detection function: single phase or three phase heater detection function.
Event input points: -.
Transfer output: -.
Communication: - E3Z-LT81-D 2M.
New program type.
A new type of liquid crystal with high performance cost ratio is adopted in the 256 paragraph,
Visual angle, contrast can be improved .
Can be set up to 8 procedures (mode) x 32 (step) procedure.
High resolution 5 bit display / can display 0.01 degrees C (to achieve a small size of 48 x 48mm).
High speed sampling period 60ms.
Full of all models (capable of thermocouple /Pt/ analog input switching),
1 machines to support a variety of sensors.
Add PV/SV state display function, to see the state of the thermostat
(automatic / manual, RUN/RESET, alarm),
Interactive display PV/SV.
By supporting software (Ver.4.3 CX-Thermo),
In simple arithmetic functions (AND/OR logic and delay).
Setting the program settings that can perform flexible contact output.
The control output ON/OFF times counting function ccan predict the fault off the internal relay of the temperature controller OMRON E3Z-LT81-D 2M. Type: rectangle.
Screen mode: no segmentation.
Light way: incandescent lamp.
Power supply voltage: 28V.
Operation Department color: red.
Square 40mm body of the indicattorr light series OMRON E3Z-LT81-D 2M.
The same type as the A3S series button switch.
Easy to install from the front panel and no tools to carry out the lamp replacement.
E3Z-LT81-D 2M Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=E3Z-LT81-D 2M&select=5