Memory format: RAM.
Number of steps: up to 16000 steps can be used.
Battery support: required.
Method for writing and deleting: the device is installed on the PLC, and is written and deleted by the peripheral device. Oil resistant cap for 5.7 inch screen.
Applicable models: GT15, GT11, GT10. Input type: DC input, positive common end MITSUBISHI HC-MFS/KFS43BG1(1/12).
Input points: 8 points.
Enter the response time: 1.5ms the following HC-MFS/KFS43BG1(1/12)
Rated input voltage / current: DC24V/5mA.
External connection: 3 wire.
Sensor connector type (E-CON type).
Using industry standard E-CON type.
Simple wiring through sensor connector.
When installing the module can choose to use the DIN guide rail or screw mounting MITSUBISHI HC-MFS/KFS43BG1(1/12).
3 wire sensor input. MITSUBISHI inverter FR-A740 series .
Voltage level: 3 phase 400V.
Frequency converter capacity: 315KW.
Frequency converter is the application of frequency conversion technology and micro electronics technology, by changing the motor operating power frequency mode to control the AC motor power control equipment MITSUBISHI HC-MFS/KFS43BG1(1/12).
The converter is composed of rectifier (AC), filter, inverter (DC), braking unit, driving unit, micro processing unit of the detection unit .
Inverter by the internal IGBT to adjust the output power supply voltage and frequency,
According to the actual needs of the motor to provide the required power supply voltage, and then achieve the purpose of energy saving, speed control, in addition to the,
Inverter has a lot of protection functions, such as over current, over voltage, overload protection and so on. Memory card interface (AD59-MEF), parallel interface.
On-line debugging is the process that will through the simulation debugging to further carry on the on-line unification to adjust.
On-line debugging process should be step by step,
From MITSUBISHI PLC only connected to the input device, and then connect the output device, and then connect to the actual load and so on and so on step by step.
If you do not meet the requirements, the hardware and procedures for adjustment.
Usually only need to modify the part of the program can be. Output points:: 32 points
Output form: TTransistor (source) HC-MFS/KFS43BG1(1/12).
Connection status: connector.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion modulee: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points HC-MFS/KFS43BG1(1/12).
HC-MFS/KFS43BG1(1/12) Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=HC-MFS/KFS43BG1(1/12)&select=5