Input type: DC input, positive common end.
Input points: 4 points.
Input response time: 0.5ms below /1.5ms.
Rated input voltage / current: DC24V/4mA.
External connection: 3 wire.
Sensor connection type.
Minimum size of industry.
When installing the module can choose to use the DIN guide rail or screw mounting FX3U-4AD-PNK-ADP Price.
3 wire sensor input. Motor series: low inertia, medium and small capacity.
Using a serial absolute / incremental encoder FX3U-4AD-PNK-ADP
Rated output power: 0.4kw.
Rated speed: 3000rpm.
With the brake: without.
Shaft end: straight shaft.
Comparison of single phase induction motor and servo motor.
The working principle of the AC servo motor is similar to that of the single phase induction motor,
But the rotor resistance of the former is much larger than that of the latter,
So the servo motor is compared with the single machine asynchronous motor,
There are three notable features:
1, large starting torque FX3U-4AD-PNK-ADP Price.
2, a wide range of operation.
3, no rotation phenomenon.
AC servo motor running smoothly, low noise FX3U-4AD-PNK-ADP Price.
But the control characteristic is non-linear, and because the rotor resistance is big, the loss is big, the efficiency is low,
Therefore, compared with the same capacity DC servo motor, the volume is large and the weight is heavy,
So it is only suitable for 0 . 5-100W small power control system. Power: 1.5kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Type: general purpose AC servo amplifier MR-E series.
Rated output: 1.0kw.
Interface type: analog input interface.
KH003 special mark for Super MR-E.
Servo amplifier terminals are used to reduuce the required wiring time .
TThe connector is located in front of the servo amplifier, which is convenient for cable connection MITSUBISHI FX3U-4AD-PNK-ADP.
The gain adjustment can be easily carried out by the real-time automatic tuning function.
Wide use.
Machining equipmennt and machine tool feed MITSUBISHI FX3U-4AD-PNK-ADP.
Used for food, packaging equipment and feeding device.
For textile machinery, etc..
Can improve the performance of equipment.
FX3U-4AD-PNK-ADP Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FX3U-4AD-PNK-ADP&select=5