Cable length: 0.7m.
For the connection between QnAS/AnSCPU/ motion controller GOT (A Series) and CPU.
Applicable models: GT16, GT15, GT11. DC input points: 16 points.
Input voltage and current: 7mA, DC24V.
Response time: 10ms.
16 point /1 a public side.
Positive / negative sharing.
40 point terminal station MITSUBISHI FX2N-5A.
MITSUBISHI PLC protection and chain procedures.
Protection and chain is an indispensable part of the program, must be carefully considered
FX2N-5A
It can avoid the control logic confusion caused by illegal operations.
MITSUBISHI PLC initialization procedure. After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system MITSUBISHI FX2N-5A.
The main contents of the initialization program are: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc..
MITSUBISHI PLC program simulation debugging
The basic idea of program simulation debugging is,
In order to facilitate the form of simulation to generate the actual state of the scene,
Create the necessary environmental conditions for the operation of the program MITSUBISHI FX2N-5A.
Depending on the way the field signals are generated,
The simulation debugging has two forms of hardware simulation and software simulation. Total input and output points: 8 points.
Output points: 8 points.
Output type: transistor output.
FX Series in the compact body built in superior performance, and strive to operate simple.
In addition, rich options can meet the various needs of customers.
In the virtual factory will be rich in the function of a part of the introduction.
It is easy to control the analog quantity of the application.
Can be extended to all models in the FX series analog devices.
Function extension board, special adapter without programming can be used for communication.
FX2N extension module.
The expansion module is an input and outpuut expansionn device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect FX2N-5A.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When coonnecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V FX2N-5A.
The number of connection points depends on the basic unit and the expansion unit.
FX2N-5A Operation manual/Instructions/Model selection sample download link:
/searchDownload.html?Search=FX2N-5A&select=5