Cable length: 3m.
For connection between QnA/A/FXCPU (D-SUB25 pin connector) and GOT.
Connection between serial communication unit (AJ71QC24-R4) and GOT.
Applicable models: GT10, GT21. Input and output points: 256 points.
Input / output data points: 256 points.
Program capacity: 6k.
Basic command processing speed (LD command) s:1 MITSUBISHI FX1N-60MR-D. 0.
Internal storage RAM memory capacity: 16k.
Optical data communication line function with power supply FX1N-60MR-D
User program storage capacity: it is a measure of how much the user application can store the number of indicators.
Usually in words or K words as units. 16 bit binary number is a word,
Every 1024 words are 1K words MITSUBISHI FX1N-60MR-D. PLC to store instructions and data in words .
General logical operation instructions each account for 1 words. Timer / counter,
Shift instruction accounted for 2 words. Data operation instructions for 2~4.
Integral type: the PLC components are installed together or a few pieces of printed circuit board,
And together with the power supply installed in the casing to form a single overall called the host or the basic unit, small, ultra small PLC using this structure MITSUBISHI FX1N-60MR-D.
Modular: PLC is the basic components of a separate module.
Medium and large PLC used this way. Easy maintenance. RS-232 2 channel.
Transmission speed: 2 channel total is 115.2kbps.
Equipment layer / field bus CC-Link device layer is the PLC and other control devices and sensors and drive devices connected to the field network,
Network for the lowest layer of the whole network system.
Using CC-Link field bus connection, the number of wiring is greatly reduced,
Improve the maintainability of the system.
And, not just the amount of data ON/OFF and other switches,
Can also be connected to the ID system, bar code reader, inverter, man-machine interface and other intelligent devicess,
From the comppletion of a variety of data communication, the management of the terminal production information can be realized,
On the centralized management of the state of the machine movement,
Make maintenance work efficiency also greatly imprroveed FX1N-60MR-D FX1N-60MR-D.
Q series PLC in the use of CC-Link function better,
And easier to use. Needle number: 40.
Specification: loose wire connector, 5 sets (0.3mm 2).
FX1N-60MR-D Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FX1N-60MR-D&select=5