Protective film for 10.4 inch screen.
Scrub (frame: white), 5.
Applicable model: GT15. Convert connector to screw relay terminal.
The action of the signal of the conversion module is shown in the light of the lamp.
Positive common end display. Connect to read and write 1Ch.
ID system interface module MITSUBISHI AJ65SBTB32-16KDT28.
ID controller M-688-001/002 BIS can be installed directly to the Q series of substrates,
Control module for reading and writing ID tag data through a programmable logic controller AJ65SBTB32-16KDT28
The ladder diagram of M-688-002 BIS is compatible with QD35ID1/2.
2 antennas can be connected, and the parallel processing of the 2 channels can be simultaneously carried out MITSUBISHI AJ65SBTB32-16KDT28.
Can use all ID tags in the M BIS series .
ID series /BIS system is an industrial automation ID system which can use the electromagnetic combination method to read and write data.
ID tag has a variety of sizes and storage capacity.DC input points: 2 points.
Input voltage and current: 7mA, DC24V.
Input response time: 10ms.
2 point /1 a public side MITSUBISHI AJ65SBTB32-16KDT28.
Positive / negative sharing.
Output points: 2 points.
Output voltage and current: DC24V/AC240V, 2A/1 point, 4A/1 common end .
Output response time: 2ms.
2 point /1 a public side.
Output form: relay.
16 point terminal station.
MITSUBISHI PLC protection and chain procedures.
Protection and chain is an indispensable part of the program, must be carefully considered.
It can avoid the control logic confusion caused by illegal operations.
MITSUBISHI PLC initialization procedure. After MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system.
The main contents of the initialization program are: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc..
MITSUBIISHI PLC program simulaation debugging
The basic idea of program simulation debugging is,
In order to facilitate the form of simulation to generate the actual state of the scene,
Create the necessary environmental conditions for the operation of thee prrogram AJ65SBTB32-16KDT28 AJ65SBTB32-16KDT28.
Depending on the way the field signals are generated,
The simulation debugging has two forms of hardware simulation and software simulation.
AJ65SBTB32-16KDT28 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=AJ65SBTB32-16KDT28&select=5