The input and output module installation number: 5.
Can install module: MELSEC-Q series module.
DIN guide rail mounting adapter type: Q6DIN2.
Size (H) * (44.1mm) * (W) * (D): * 245mm * 98mm.
Substrate module for mounting various modules of MELSEC-Q series.
Extended use of Q series expansion substrates in the following extensions MITSUBISHI A6RCON-F. ""MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series A6RCON-F
Rated output: 2.0kw.
Built in positioning function.
Voltage: 3 phase AC200VAC or single phase AC230V.
Compatible with "MR-J2S- CP-S084" - servo amplifier and interface unit "MR-J2S-TO1" positioning by CC-Link
Simply setting the point table MITSUBISHI A6RCON-F.
AC servo can be used as the driving source of the field network .
Using servo amplifier built-in positioning function, position data and speed data, you can set the CC-Link.
Start, stop and display can also be transmitted through the CC-Link.
Serial communication reduces wiring.
AC servo distributed control system can be easily constructed. "Enter 16 points: 24VDC.
Response time 1 MITSUBISHI A6RCON-F. 5ms.
Waterproof type.
4 wire type.
Waterproof connector type.
MITSUBISHI PLC hardware implementation
Hardware implementation is mainly for the control cabinet and other hardware design and field construction .
Design control cabinet and the operating table and other parts of the electrical wiring diagram and wiring diagram.
Electrical interconnection diagram of each part of the design system.
According to the construction drawings of the site wiring, and carry out a detailed inspection.
Because the program design and hardware implementation can be carried out at the same time,
So the design cycle of the MITSUBISHI PLC control system can be greatly reduced.
MITSUBISHI PLC online debugging.
On-line debugging is the process that will through the simulation debugging to furtherr carry on thhe on-line unification to adjust A6RCON-F.
On-line debugging process should be step by step,
From MITSUBISHI PLC only connected to the input device, and then connect the output device, and then connect to the actual load and so on and so on stepp bby step A6RCON-F.
If you do not meet the requirements, the hardware and procedures for adjustment.
Usually only need to modify the part of the program can be.
A6RCON-F Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=A6RCON-F&select=5