Drive unit 200VAC/400VAC level.
MITSUBISHI motor general AC servo amplifier MELSERVO-J3 series.
Need conversion unit MR-J3-CR55K4) supporting the use of.
Rated output: 55kw.
Interface type: SSCNET type III fiber communication.
Special features: integrated driver security.
Power specification: three phase AC400V MITSUBISHI .
High speed serial communication between the SSCNET and the servo amplifier by using the fastest up to 0 Q61P-A244ms communication cycle,
A fully synchronous control system can be constructed.
It is only necessary to insert the special optical fiber into the joint to form SSCNET III network, which greatly reduces the wiring work and reduces the possibility of false wiring MITSUBISHI .
Due to the adoption of the optical fiber communication, the anti noise ability can be greatly improved and the long distance wiring of 50 meters (maximum 800 meters x 16 axes) can be realized .
A servo amplifier to meet the full closed loop control function MR-J3-B-RJ006.
Suitable for mechanical servo optimization and adjustment!
More advanced optimization adjustment function and control function to maximize mechanical properties MITSUBISHI . Axis of control: 16.
Compact Q170MCPU integrated power supply module, PLC and motion controller,
And built in the packaging equipment used in the incremental synchronous encoder signal and signal detection signal required for the interface,
Do not need to add the appropriate module.
Reduce the design cost of the system expansion!
Although the structure is compact, but as a motor controller based on the iQ platform of MITSUBISHI motor,
Q170MCPU as an independent motion controller, also has high performance and easy to use.Twisted pair cable.
Single bus.
MELSECNET/B (Master / local station).
According to the control requirements of the system, using the appropriate design method to design MITSUBISHI PLC program.
Procedures to meet the requirements of system control as the main line,
Write one by one to achieve the control function or the sub task of the program,
Gradually improve the functions specified by the system.
MITSUBISHI PLC initiallization procedure . Affter MITSUBISHI PLC on power, the general need to do some of the initial operation,
In order to start making necessary preparations, to avoid the wrong operation of the system MITSUBISHI Q61P-A2.
The main contents of the initialization program arre:: to some data area, counter and so on,
Data needed to restore some of the data area,
Set or reset some relays,
For some initial state display, etc MITSUBISHI Q61P-A2. .
Q61P-A2 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=Q61P-A2&select=5