Analog input points: 8 channels
Voltage input range: DC-10~10V.
Current input range: DC4~20mA, DC-20~20mA.
The resolution of 14 bit binary + symbol 1 bit, 13 bit binary + symbol 1 bit analog input module.
Voltage input, current input, thermocouple temperature sensor input of the 8 channel can be carried out MITSUBISHI FX3U-CNV-BD.
The channel can be used as the unit, the mixed use of voltage, current, thermocouple input FX3U-CNV-BD Input type: DC input, positive common end.
Input points: 16 points.
Enter the response time: 0.5ms/1.5ms the following.
Rated input voltage / current: DC24V/4mA.
External connection: 1 wire.
MIL connector type.
Minimum size of industry MITSUBISHI FX3U-CNV-BD.
Relay terminal, terminal station conversion module and electromagnetic valve, etc . are connected to a simple MIL connector.
Simply remove the connector can be replaced with a simple module.
Additional module power supply, I/O power sharing.
No additional I/O power supply, you can reduce the cost and set space. Drive: MR-H_ACN series SSC-NET compatible AC servo.
Rated output: 2 MITSUBISHI FX3U-CNV-BD. 0KW.
The servo controller can easily transfer the operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single .
The servo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control.
The general inverter can only form an open loop control system.
Servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter. A pack of 20.
Applicable models:
AJ65SBTC - - - type remote I/O module.
AJ65VBTCU - - - type remote I/O module.
AJ65VBTCU- - type remote I/O module. Motor series: low inertia, medium capacity.
Rated output power: 25.0kw.
Rated speed: 1000rpm.
With the brake: without.
Shaft end: straight shaft.
The rottor of the servoo motor is a permanent magnet, which is controlled by the U/V/W,
The rotor rotates under the action of the magnetic field, and the encoder feedback signal of the motor is given to the driver,
According to the feedback value and the ttargget value, the driver adjusts the rotation angle of the rotor FX3U-CNV-BD FX3U-CNV-BD.
Accuracy of the servo motor depends on the accuracy of the encoder (number of lines).
FX3U-CNV-BD Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FX3U-CNV-BD&select=5