Self service (IN, OUT): SI optical cable.
Other aspects (IN, OUT): SI optical cable.
Data link anomaly Bureau bypass.
Inter agency extension. Cable length: 5m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT. Output type: transistor output, drain type.
Output points: 16 points MITSUBISHI FR-A820-02330-2-60.
OFF leakage current: 0.25mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0 FR-A820-02330-2-605A.
External connection: 2 wire.
Waterproof connector type.
Strong waterproof type of IP67 protection grade.
No need to stop the system can be replaced module.
Without the use of tools can be a simple connection, save time MITSUBISHI FR-A820-02330-2-60.
Terminal resistor built-in.
Can be installed along the 6 direction .
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness MITSUBISHI FR-A820-02330-2-60.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer. Type of input: DC leakage.
Input points: 32 points.
Input voltage: DC12/24.
Input current: 3/7mA.
Output type: transistor drain type.
Output points: 32 points.
Common public end points: 32.
PLC is introduced by the relay control technology after the development of micro processing technology,
Can be easily and reliably used for switching control.
As the analog quantity can be converted into digital quantity, the number of digital quantity is just a number of switching value,
Therefore, after the conversion of analog, PLC can also be reliable for processing control.
Because the continuous production process often has the analog quantity, the analog quantity control is sometimes called process control.
Analog quantity is not electricity, and PLC can only handle digital quantity, quantity of electricity.
All to realize the conversion between them to have the sensor, the analog quantity into a number of power.
If this power is not standard, but also through the transmitter,
The non-standard power into a standard electrical signal, such as 1-5V, 4-20mA, 0-10V, etc..
At the same time, there is also an analog input unit (A/D),
Transform these sstandard electrical siggnals into digital signals,
The analog output unit (D/A), in order to transform the digital quantity after PLC processing into analog quantity -- standard electric signal FR-A820-02330-2-60.
So the standard telecommunication number, the conversiionn between the number of operations to use a variety of computing FR-A820-02330-2-60.
This requires the resolution of the analog unit and the standard electrical signal.
FR-A820-02330-2-60 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=FR-A820-02330-2-60&select=5