MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 2.2kw.
SLD converter rated current: 5.2A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed MITSUBISHI AJ71J92-S3.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption AJ71J92-S3
Give full play to the performance of the motor.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency MITSUBISHI AJ71J92-S3.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control . Max input / output points: 20 points.
Supply voltage: 100 - 240VAC.
Input points: 12 points.
Output points: 8 points.
Output type: relay.
Power consumption (W): 20.
Weight (kg):0.4.
Size (WxHxD) mm:75x90x75 MITSUBISHI AJ71J92-S3.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types .
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor.
The series PLC can not be brought with the expansion module, but can be installed by the BD board to extend a small amount of I/O.
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication. SRAM memory card.
RAM capacity: 128KB. I/O slots: 5 slots.
Could you install the power module.
Outline dimension: 315*130.
There are two types of extended floor,
A power module can be inserted, and the other onee is not .
The choice of any type of substrate depends on the total DC5V current consumption and the power supply on the CPU main substrate AJ71J92-S3.
If the total demand is less than the power output, no additional power supply,
Then you can choose a more ecconnomical expansion board AJ71J92-S3.
Both ends of the main base plate of the CPU have an expansion interface, and can be used for extending the cable connection.
AJ71J92-S3 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=AJ71J92-S3&select=5