1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 0.4kw.
Interface: SSCNET III /H.
Power supply: single phase AC100V power supply.
The servo amplifier is limited to 0.4kW.
Special specification: support for CC-LinkIE.Field network motion control.
Servo amplifier supporting IE Field CC-Link network MITSUBISHI MR-J3-350B4.
Ethernet based open network, support for motion control MR-J3-350B4
Not only inherited the original product of high performance and high reliability, but also made a further improvement beyond imagination.
MELSERVO-J4 grand debut.
Servo market for the star of tomorrow. World class servo products MITSUBISHI MR-J3-350B4.
The new generation of MELSERVO should be what kind of? The answer to this question is already floating
Out of the water . MELSERVO-J4, it represents the whole digital, the original high performance based on an evolutionary.
Is also fully meet the requirements of human beings and the environment MELSERVO latest masterpiece.
For example, the safety and environmental requirements for the safety of human use and the safety specifications and "to Use Easy" design MITSUBISHI MR-J3-350B4.
To meet the needs of the environmental protection era of energy-saving performance .
Beyond the performance of the evolution of MELSERVO-J4, shocking debut!SRAM+E2PROM memory card.
RAM capacity: 128KB.
E2PROM capacity: 128KB. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 10.4 inches.
Display color: 256 color or more color.
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch pooint,
Must be ree calibrated to the touch screen system MR-J3-350B4.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MR-J3-350B4.
MR-J3-350B4 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-J3-350B4&select=5