Servo motor series: medium inertia, small capacity.
Rated output: 1.5kw.
Rated speed: 2000r/min.
Electromagnetic brake: incidental.
Power supply: 400V.
Stable driving of medium capacity and medium inertia type products.
Through the optimization of structural design, to achieve the minimum length of the industry MR-H11KTN Price.
High speed & high torque. Shorten the positioning time, achieve high-speed equipment MR-H11KTN
Reducing the electric torque ripple.
Through the combination of the optimal number of the motor and the slot number, the torque ripple is greatly reduced,
To further realize the smooth constant speed device.
Improve the environmental performance of HG-SR, HG-JR series of products using IP67 MR-H11KTN Price. Input type: DC input, positive public end / negative public end .
Input points: 8 points.
Input response time: 0.5ms below /1.5ms.
Rated input voltage / current: DC24V/4mA.
External connection: 2 wire.
Spring clip terminal.
Do not need to re tighten, suitable for wire specifications for 0.3~1.5MM square.
Terminal block is 2 piece structure MR-H11KTN Price.
An input module shared by the common terminal of the positive and negative .
The 8 point of the output module is appended to the source type.
Can be installed along the 6 direction. Input voltage range: AC100 ~ 120V.
Output voltage: DC24V.
Output current: 0.6A.
Relay output interface circuit of PLC
Working process: when the internal circuit output digital signal 1,
There is a current flowing through, the relay coil has a current, and then the normally open contact is closed,
Provide load current and voltage.
When the internal circuit outputs a digital signal 0, there is no current flowing through it,
The relay coil does not have a current, and the normally open contact is broken off,
A current or voltage that is disconnected from the load.
It is through the output interface circuit to the internal digital circuit into a signal to make the load action or not action.
I/O points is an important indicator of PLC.
Reasonable selection of I/O points can not only satisfy the control requirements of the system,
And the total investment of the system is the lowest.
The input and output points and types of PLC should bee determined according too the analog quantity and switch quantity of the controlled object,
Generally an input / output element to take up an input / output point MITSUBISHI MR-H11KTN.
Taking into account the future adjustment and expansion,
In general should be estimaateed on the total number of points plus the amount of spare 20%~30% MITSUBISHI MR-H11KTN.
The following describes the centralized control system I/O points of the estimate.
MR-H11KTN Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-H11KTN&select=5