Cable length: 2m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-SFS; HC-LFS; HC-RFS; 2000r/min HA-LFS; HC-UFS servo motor.
-H products have a long flex life. MITSUBISHI PLC online debugging.
On-line debugging is the process that will through the simulation debugging to further carry on the on-line unification to adjust MITSUBISHI .
On-line debugging process should be step by step,
From MITSUBISHI PLC only connected to the input device, and then connect the output device, and then connect to the actual load and so on and so on step by step MR-J3-40B-RJ004
If you do not meet the requirements, the hardware and procedures for adjustment MITSUBISHI .
Usually only need to modify the part of the program can be. Cable length: 5m.
For MR-J2S-700A (4) /CP/CL or less .
Encoder for HC-SFS; HC-LFS; HC-RFS; 2000r/min HA-LFS; HC-UFS servo motor.
-L represents bending life. Total input and output points: 32 points.
Input points: 16 points.
Output points: 16 points.
Output type: relay output.
Power supply voltage: AC100-240V.
Input signal voltage: DC24V MITSUBISHI .
8K capacity of the RAM memory, the maximum can be extended to 16K.
CPU arithmetic processing speed of 0 . 08 S/ basic instructions.
On the right side of the FX2N series can be connected to the input and output expansion modules and special function modules.
The basic unit is built in the 2 axis independent maximum 20kHz positioning function (transistor output type).
Quick disconnect the terminal block, which adopts excellent maintainability to quickly disconnect the terminal blocks, even if the cable is then replaced by the cable.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application of the continuous scan time.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017).
Note recording function, Component annotation can be recorded inn the program register .
Onlinee program editor, online change the program will not lose the working hours or stop production operation MITSUBISHI MR-J3-40B-RJ004.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software caan monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to protect your program MITSUBISHI MR-J3-40B-RJ004.
MR-J3-40B-RJ004 Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-J3-40B-RJ004&select=5