Protective film for 15 inch screen.
Scrub (frame: white), 5.
Applicable model: GT16. MITSUBISHI inverter series: FR-A800.
Voltage level: three phase 400V.
Power: 250kw.
SLD converter rated current: 610A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Mirror like ultra fine processing MITSUBISHI .
In order to adapt to the new material diversification, the machine adopts the most cutting-edge technology, more than ever more slim hard MR-H40ACN
In order to be able to realize the fine cutting, grinding on the hard and hard material,
The need for high-speed operation has become more and more strong.
In order to cope with the increasing demand of logistics, every port in the world has a crane in every day MITSUBISHI .
A container filled with cargo.
We can achieve a new type of inverter products under the conditions of low speed and high torque to achieve smooth cargo handling operations,
Carry on the smooth movement to the heavy. MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 3.7kw.
SLD converter rated current: 8 MITSUBISHI . 3A.
Structure and function: Standard model.
Type: CA .
Substrate coating: have.
2 times the power consumption of the wind turbine and pump and the speed of the 3 power consumption is proportional to the speed of the rotating speed.
Through the speed control of the frequency converter to adjust the air flow, can reduce the power consumption.
Give full play to the performance of the motor.
The excitation current is always adjusted to the best state, which can improve the efficiency of the motor.
Load torque is smaller, can further improve energy efficiency.
For example, when a general motor is used, the optimal excitation control mode in the 4% motor load torque is about 30% more than that of the V/F control. Input type: DC input, positive public end / negative public end.
Input points: 8 points.
Input response time: 0.5ms below /1. .5ms.
Rated input voltagge / current: DC24V/4mA MITSUBISHI MR-H40ACN.
External connection: 2 wire.
Spring clip terminal.
Do not need to re tighten, suitable for wire specifications for 0.3~1.5MM square.
Terminal block is 2 piece structure.
An input module shared by the coommon terminal of the positive and negative MITSUBISHI MR-H40ACN.
The 8 point of the output module is appended to the source type.
Can be installed along the 6 direction.
MR-H40ACN Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=MR-H40ACN&select=5