High-Speed and High-Precision.
G5 Series MECHATROLINK-II.
Communications with the Controller.
Data transfer using MECHATROLINK-II.
Communications:
All control data that can be interfaced between the Servo Driver,
and the Controller is transmitted using data communications.
This enables maximizing the Servomotor performance without,
restricting the transmission performance of the control signals XG4M-2630-U
Having a communications module built into the Servo Driver,
significantly saves space in the control panel. Actuator: Plunger.
Type: Standard.
Compact, General-purpose Horizontal.
Switches.
Models for Microloads Added to Series OMRON XG4M-2630-U.
Approved by EN, UL, CSA, and CCC (Chinese standard).
(Ask your OMRON representative for information on approved models . ),
Incorporates a switch with a durable coil spring in a tough,
high precision case.
Compact and uses a single basic switch for applications where,
strength is required.
Models for microloads and models with operation indicators,
added to series.
Terminal protective cover can be switched to wire cable from,
either the left or right OMRON XG4M-2630-U.
Sealing characteristics that meet IEC IP67 degree of protection. Time specification: Instantaneous type.
Current setting range: 20 to 65 A.
Operating voltage: 200/220/240 VAC.
Resetting method: Manual.
Solid-state Relay Enables Choice of Three.
Operating Functions (Overcurrent, Open,
phase, and Reverse-phase).
Protects 3-phase induction motors and their loads from damage.
Selection and combination of operating functions from overcur,
rent, open-phase, and reverse-phase.
Circuit and output relay operation can be checked by just operat,
ing the test button.
The set time value can be checked easily because operation time,
is indicated from the start of operation.
Space-saving, integrated construction.
Note: If the K2CM is used with an inverter, the operating conditions will,
depend on the load wiring length, inverter carrier frequency, basic,
frequency, and load conditions. Error will occur in the operating,
values of the overload elements. It is recommended to test operation,
before using the K2CM. Size: M8, Non-shielded.
Sensing distance: 4.0 mm.
Connection: M12 connector.
Body material: Brass.
Thread length (overall length): 27 (43).
Ouutput configurattion: NPN XG4M-2630-U.
Operation mode NC.
Safe Mounting with Greater.
Sensing Distance.
Ensures a sensing distance approximately 1.5 to 2,
times larger than that of any conventional OMRON Sensor.
Problems such as the collision of workpiecees are eliminated XG4M-2630-U.
Full range of standard sizes (M8, M12, M18 and,
M30; both long and short barrels).
Modular construction simplifies customization.
XG4M-2630-U Operation manual/Instructions/Model selection sample download link: /searchDownload.html?Search=XG4M-2630-U&select=5