A power supply connector set for HC-KFS; HC-MFS; 3000r/min HC-UFS servo motor electromagnetic brake.
For MR-J2S-11KA (4) MR-J2S-22KA to (4). The length of the line: 2M.
IP level: IP65.
Direct type.
Bending life: standard.
Connector kit for motor electromagnetic brake.
Cable for electromagnetic brake, for HF-KP/HF-MP series (motor shaft with side extraction) MITSUBISHI MR-J2S-10CP1 PDF datasheet. Drive unit 200VAC/400VAC level MR-J2S-10CP1
MITSUBISHI motor general AC servo amplifier MELSERVO-J3 series.
Need conversion unit MR-J3-CR55K) supporting the use of.
Rated output: 55kw.
Interface type: general pulse interface type.
Power specification: three phase AC400V.
Pulse train and analog input as universal interface.
Can choose the position, speed and torque control mode MITSUBISHI MR-J2S-10CP1 PDF datasheet.
The use of advanced tuning features such as advanced vibration suppression control and adaptive filter,
Greatly improve the performance of the machine.
MR-J3, your partner.
Higher performance, more features, more convenient to use.
Highest performance in the industry.
Speed response frequency up to 2.1kHz. Drive: MR-H_ACN series SSC-NET compatible AC servo.
Rated output: 0 MITSUBISHI MR-J2S-10CP1 PDF datasheet. 4KW.
The servo controller can easily transfer the operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single.
The servo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control.
The general inverter can only form an open loop control system.
Servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter. MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 0.4kw.
Built in positioning function.
Voltage: 3 phase AC200VAC or single phase AC230V.
Compatible with "MR-J2S- CP-S084" - servo amplifier and interface unit "MR-J2S-TO1" positioning by CC-Linkk
Simply setting the point table MR-J2S-10CP1 PDF catalog.
AC servo can be used as the driving source of the field network.
Using servo amplifier built-in positioning function, position data and speed data, you can set the CC-Link.
Start, stop and ddisplay can also be transmitted through the CC-Link MR-J2S-10CP1 PDF catalog.
Serial communication reduces wiring.
AC servo distributed control system can be easily constructed.