The length of the line: 2M.
IP level: IP65.
Direct type.
Bending life: high bending life.
Connector kit for motor electromagnetic brake.
Cable for electromagnetic brake, for HF-KP/HF-MP series (motor shaft with side extraction). MR-J2M multi axis servo amplifier drive unit.
Rated output: 0.1kw.
Servo system is used to achieve the following purposes:
1, with a small power command signal to control the power load MITSUBISHI MR-H11KACN PDF catalog MR-H11KACN Gun control and rudder control is a typical example.
2, in the absence of mechanical connection, the input shaft control is located in the distance of the output shaft, to achieve remote synchronous transmission.
3, so that the output of the mechanical displacement of the precise tracking of electrical signals, such as records and instructions, etc MITSUBISHI MR-H11KACN PDF catalog. . Cable length: 30m.
For MR-J2S-700A (4) /CP/CL or less.
Encoder for HC-SFS; HC-LFS; HC-RFS; 2000r/min HA-LFS; HC-UFS servo motor.
-H products have a long flex life.
MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 0.6kw.
SSCNET interface.
Voltage: 3 phase AC200VAC or single phase AC230V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0 MITSUBISHI MR-H11KACN PDF catalog. 888ms.
Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
This simple connection method reduces the routing time and helps to prevent noise.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the servo amplifier, which can form the absolute value system.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use. Multi axis integrated servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Axis number: 3 axis.
Rated output A axis (Note 1): 0.4kw.
Rated output B axis (Note 1): 0.4kw.
Rated output C axis (Note 1): 0.4kw.
Interface: SSCNET III /H.
Note the 1:A axis, B axis, C axis indicates the name of a type of multi axis servo amplifier axis. The C axis represents the 3 axis one type servo amplifier.
Support SSCNET III /H. 3 axis one type servo amplifier capable of driving 3 servo motors through a single module.
More energy savving, space saving, less wiring, low cost MR-H11KACN PDF datasheet.
Inherited the high performance and high reliability.
Will, as always, adhere to and uphold the excellent quality of MELSERVO.
MR-J4 has inherited the excellent design of existing prroducts MR-H11KACN PDF datasheet.
Its essence to its dregs, create advantage and cost effective utilization rate,
Make full use of renewable resources, to create a new product.