Type: MR-J series.
Rated output: 3.5KW.
Applicable motor series: HA-FF, HA-SE.
Voltage: three phase AC220V.
It is very helpful to improve the stability of the low speed control of the servo motor.
But there is no direct effect to improve the accuracy of position control.
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control MR-J3-100B4-RJ006 PDF datasheet MR-J3-100B4-RJ006
This can be effectively used in the use of the robot control of the indexing table.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment MR-J3-100B4-RJ006 PDF datasheet.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor.
Encoder serial communication system, the communication frequency can only be limited to 10M. Drive: MR-H_ACN series SSC-NET compatible AC servo.
Rated output: 0.1KW.
The servo controller can easily transfer the operation module and the field bus module through the automation interface,
At the same time using different fieldbus modules to achieve different control modes (RS485, RS232, optical fiber, InterBus, ProfiBus),
And the control mode of general inverter is single MR-J3-100B4-RJ006 PDF datasheet.
The servo controller is directly connected with a rotary transformer or an encoder, which forms a closed loop of speed and displacement control.
The general inverter can only form an open loop control system.
Servo controller of the control parameters (such as steady-state accuracy and dynamic performance) is better than the general inverter. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 15.0kw.
Interface type: SSCNET type III fiber communication.
Full closed loop control.
Power specification: three phase AC400V.
High precision and high response location control.
Full closed loop control can be realized by double feedback control method.
Dual feedback control can be performed between the servo motor encoder and the load side encoder.
MR-J3-B-RJ006 can be used in conjunnction with a number of manufacturers of linear encoder,
Users can build the system according to their own accuracy requirements MR-J3-100B4-RJ006 PDF catalog. ABS type linear encoder using serial interface,
No need to install the battery on the serrvo amplifier can easily build the absolute position detection system MR-J3-100B4-RJ006 PDF catalog.
Flexible system configuration.
Can achieve higher load side positioning accuracy!