Drive: MR-H_ACN series CC-LINK features.
Rated output: 2.0KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions MR-J2S-20CP1 PDF catalog.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data
MR-J2S-20CP1 Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-J2S-20CP1 PDF catalog.
Usually, such testing system is only used to test the rotational speed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive. Adapter kit (for CN3)MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series MR-J2S-20CP1 PDF catalog.
Rated output: 5.0kw.
Interface type: SSCNET type III fiber communication.
Full closed loop control.
Power specification: three phase AC400V.
High precision and high response location control.
Full closed loop control can be realized by double feedback control method.
Dual feedback control can be performed between the servo motor encoder and the load side encoder MITSUBISHI Built in positioning function servo amplifier PDF catalog.
MR-J3-B-RJ006 can be used in conjunction with a number of manufacturers of linear encoder,
Users can build the system according to their own accuracy requirements MITSUBISHI Built in positioning function servo amplifier PDF catalog. ABS type linear encoder using serial interface,
No need to install the battery on the servo amplifier can easily build the absolute position detection system MITSUBISHI Built in positioning function servo amplifier PDF catalog.
Flexibble system configuration MR-J2S-20CP1 PDF datasheet.
Can achieve higher load side positioning accuracy!Cable length: 5.0m.
Amplifier CC-Link interface unit cable.
For MR-J2S-11KA (4) MR-J2S-22KA to (4).
Amplifier and CC-Link interface unit using 0.5 mm (1 MR-J2S-20CP1 PDF catalog. 64 ft) or shorter cables. Fiber length: 0.15 meters.
SSCNET III cables (standard optical fiber used in control cabinet).
Joints for CN1A and CN1B.