MR-J2M multi axis servo amplifier substrate.
Groove position: 8.
There are many methods for the classification of servo system, and there are three kinds of common classification methods.
(1) classification of parameters of controlled parameters.
(2) according to the type of drive components.
Servo control system according to the type of control components can be divided into mechanical and electrical servo system, hydraulic servo system (hydraulic control system) and pneumatic servo system MM-EFS30K1M4 PDF datasheet MM-EFS30K1M4
(3) according to the control principle.
Servo system can be divided into open loop servo control system, closed loop control servo system and semi closed loop servo system. Interface power supply: 24VDC plus or minus 10% MM-EFS30K1M4 PDF datasheet.
Digital input: 30 points, optocoupler isolation, drain / source type support.
Digital output: 16 points, optocoupler isolation, drain / source type support.
Analog input: 2 channels, 0 to plus or minus 10VDC (input impedance: 10~12k).
Analog output: 2 channels, 0 to plus or minus 12VDC. "MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 3.5kw MM-EFS30K1M4 PDF datasheet.
Built in positioning function.
Voltage: 3 phase AC200VAC or single phase AC230V.
Super function, excellent performance.
High performance CPU integration, greatly improve product responsiveness.
Due to the application of high performance CPU, so that the response can be greatly improved.
Speed loop frequency response increased to more than 550HZ.
MR-J2-Super series is the best device for high speed positioning applications.
Easy adjustment.
Model adaptive control / advanced real time automatic tuning. "Drive: MR-H_ACN series CC-LINK features.
Rated output: 15KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the measurement and control circuit of the system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MM-EFS30K1M4 PDF catalog.
Usually, such testing system is only used to test the rotational speeed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive MM-EFS30K1M4 PDF catalog.