Power: 2.2kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor FR-A846-04320-2-60 datasheet.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table FR-A846-04320-2-60
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor FR-A846-04320-2-60 datasheet.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Convert connector to screw relay terminal.
According to the location of the connection equipment distribution module. Convert connector to screw relay terminal.
According to the location of the connection equipment distribution module FR-A846-04320-2-60 datasheet. Positive common end use. Input signal power: 40mA. DC24V
Axis of control: 1.
Output frequency: Max 200kHz.
Weight: 0.2kg.
FX3U-1PG is a pulse output module of the maximum output 200kHz pulse train.
7 operation modes needed to take the simple position control.
The speed and the target address can be changed in the positioning operation according to the operation of the project,
Support near S shape plus deceleration. High speed positioning can be carried out smoothly.
Up to 8 units can be connected to FX3U or FX3UC.
Connecting FX3UC requires FX2NC-CNV-IF or FX3UC-IPS-5V. Max input / output points: 16 points.
Power supply voltage: 24VDC.
Input points: 8 points.
Output points: 8 points.
Output type: relay.
Power consumption: 25W.
Weight (kg):0.6.
Size (WxHxD) mm:130x90x86.
Built in CPU, power supply, input and output. By using a rich variety of functional extension boards and special adapters,
Can achieve high precision control.
Based on the function of FX2N has been greatly strengthened and enhanced.
High speed operation.
Basic instructions: 0.065 s/ instruction.
Application instruction: 0.642 s/ instruction.
Large capacity memory.
Built in program memory 64000 steps.
Flash memory cartridge with program transfer function.
Authentication。
Corresponding EN and UL/cUL authentication.
Faster and more efficient. Support high speed control and network communication, and have the function of data recording.
High speed, large capacity, multi-function high-end machine.
FX3U supports high speed processing, CC-Link communication, network communication, analog control and advanced positioning system.
Connected to the CC-Link, including the remote I/O, the maximum input and output control points up to 384 points,
Can correspond to a variety of field needs, tthe use of its scalability and flexibility to expand the scope of application of the control system FR-A846-04320-2-60 PDF datasheet.
Third generation high function micro programmable controller.
High speed, high efficiency, high performance, large capacity, and new features FR-A846-04320-2-60 PDF datasheet.
Built in high speed processing and positioning.
Control points: maximum 256 points.
Use CC-Link remote I/O for 384 points.