Type: output module.
Insulation mode: three end two-way photoelectric switch.
Action indicator: there.
Zero trigger function: No.
Applicable load of output: AC100 2A ~ 240V.
Input rated voltage: DC12V.
I/O solid state relay can be used for OMRON I/O type G7TC relay terminal.
Input and output composite input module, the output module is complete OMRON G3RV-D03SL DC24 PDF catalog.
Can be used for I/O type P7TF terminal G3RV-D03SL DC24 Can also be mixed with the I/O type G7T relay.
Can check the working status of SSR through the action indicator.
Have access to UL, CSA standard certification of the series of products have also been series (-US type)Name: Slice I/O Units; Digital I/O Units.
Specifications: 4 inputs NPN.
Standards: CE, UC1, L, N OMRON G3RV-D03SL DC24 PDF catalog.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error OMRON G3RV-D03SL DC24 PDF catalog. Category: relay output.
Points: 8 points (1a * 8).
Common line processing on the connector side: corresponding (+ public).
Rated voltage: DC24V.
To achieve the control cabinet of miniaturization / save time,
Relay terminal for 8 point output.
Small size of 136 * high 80 * 55mm. (vertical installation)
The total wiring of the connector cable is realized.
The common end can be easily connected with the independent contact and the short circuit piece.
The G70D-SOC08 and G70R-SOC08 are connected by a short circuit chip.
When the relay does not need the tool, the relay is convenient to replace the work.
With terminal cover to prevent electric shock.
Diode for internal coil surge absorption.
DIN guide rail installation, screw mounting common. Isolation: Photo-voltage coupler.
Zero cross function: No.
Indicator: Yes.
Rated output load: 0.5 A at 24 to 240 VAC, 0.5 A at 24 to 110 VDC.
Rated input voltage: 12 VDC.
100-A-max. Leakage Current, No Bleeder.
Resistor Required.
1 mA to 500 mA micro-load switching.
Switch to both AC and DC with no polarity.
Switch for aa wide range of voltages; 19 G3RV-D03SL DC24 PDF datasheet. 2 to 264 VAC, 19.2 to 125 VDC.
Switch full- and half-wave rectifier AC loads.
Same sizes and terminal arrangements as OMRON Power,
Relay MY Series.
Operating indicator provided.
Switch MY Series (without bleeder resistor) G3RV-D03SL DC24 PDF datasheet.
Superior surge absorption with a built-in varistor.
Optimum SSR to control minute load, valves, and solenoids.