1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 3.5kw.
Interface: General purpose.
Power supply: three phase AC200V.
Servo amplifier supporting universal interface.
Servo amplifier for universal interface.
Speed / torque control of position control and analog voltage command can be carried out by using pulse train command MR-J2S-40CP-S084 PDF datasheet MR-J2S-40CP-S084
Support Max instruction pulse frequency 4 Mpulses/s.
Not only inherited the original product of high performance and high reliability, but also made a further improvement beyond imagination.
Improve mechanical properties by high performance motor.
By improving the resolution and processing speed of the encoder,
The rotating servo motor has higher precision and better performance of rotation MR-J2S-40CP-S084 PDF datasheet .
Only open a key type of adjustment function, can be carried out including mechanical resonance filter, high end seismic control II, low pass filter servo gain adjustment.
Easily start advanced seismic function, it can maximize the mechanical properties.
It can automatically adjust the required response settings automatically. For HF-KP/HF-MP seriesPower: 75kw MR-J2S-40CP-S084 PDF datasheet .
Voltage: 200V.
Sine wave filter.
The voltage and current of the motor can be adjusted to a sine wave.
The sine wave filter is installed to the output terminal of the inverter.
Applicable to FR-A820-03800 (75K) above and FR-A840-02160 (75K) and above frequency converter MITSUBISHI MR-J2S-40CP-S084 PDF catalog.
Sine wave filter is equivalent to the operational characteristics of the sine wave power driver, can provide the following benefits MITSUBISHI MR-J2S-40CP-S084 PDF catalog.
Low noise.
No surge current.
Reduce motor loss (standard motor). The length of the line: 10M.
IP level: IP65.
Direct type.
The cable is not shielded.
Bending life: high bending life.
Connector kit for motor electromagnetic brake.
Cable for electromagnetic brake, for HF-KP/HF-MP series (motor shaft with side extraction) MITSUBISHI MR-J2S-40CP-S084 PDF catalog. Superior high efficiency IPM motor.
Output power: 45kw.
Rated speed: 1500r/min.
Voltage level: 400V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.4kw.
Interface type: SSCNET type III fiber communication.
Full closed loop control.
Power specification: single phase AC200V.
High precision and high response location control.
Full closed loop control can be realized by double feedback control method.
Dual feedback control can be performed between the servo motor encoder and the load side encoder.
MR-J3-B-RJ006 can be used in conjuncttion with a number of manufacturers of linear encoder,
Users can build the system according to their own accuracy requirements MR-J2S-40CP-S084 datasheet. ABS type linear encoder using serial interface,
No need to install the battery on the serrvo amplifier can easily build the absolute position detection system MR-J2S-40CP-S084 PDF datasheet .
Flexible system configuration.
Can achieve higher load side positioning accuracy!