Output type: transistor drain.
Output points: 16 points.
Load voltage: DC24.
Load current: 2A.
Connection mode: terminal row.
Common public end points: 8.
Switching value, also known as logic, refers to only two values, 0 or 1, ON or OFF.
It is the most common control, it is the advantage of PLC control,
Is also the most basic application of PLC AJ35T-M16B-R PDF catalog .
Switch volume control is designed to,
According to the current input combination of the switch quantity and the history of the input sequence,
So that PLC generates the corresponding switching output,
In order to make the system work in a certain order AJ35T-M16B-R
So, sometimes also known as the order control.
And sequential control is divided into manual, semi-automatic or automatic AJ35T-M16B-R PDF catalog .
And the control principle is decentralized, centralized and hybrid control three. 3C-2V/5C-2V coaxial cable between the single bus PC network (control station / common station) / remote I/O network (remote master).
The response time of PLC is the interval between the time of the change of the external output signal of the PLC and the time of the change of the external output signal which is controlled by it,
Lag time, this is the time constant of the input circuit,
The time constant of the output circuit, the arrangement of the user statement and the use of the instruction,
The cycle scan mode of PLC and the way of PLC to refresh the I/O and so on AJ35T-M16B-R PDF catalog MITSUBISHI AJ35T-M16B-R PDF datasheet.
This phenomenon is called the I/O delay time effect.
Switch volume control is designed to,
According to the current input combination of the switch quantity and the history of the input sequence,
So that PLC generates the corresponding switching output,
In order to make the system work in a certain order MITSUBISHI AJ35T-M16B-R PDF datasheet.
So, sometimes also known as the order control.
And sequential control is divided into manual, semi-automatic or automatic MITSUBISHI AJ35T-M16B-R PDF datasheet.
And the control principle is decentralized, centralized and hybrid control three. Program memory capacity 14K.
Input and output points to the maximum 512 points.
A scan cycle of PLC must pass throuugh three stages: input sampling, program execution and output refresh AJ35T-M16B-R datasheet.
PLC in the input sampling phase: first of all, in order to scan the sequence of all existing input latches in the input terminal of the state or input data read,
And write it into the corresponding input status register,
Refresh the input, then close the input port, enter the program execution stage AJ35T-M16B-R PDF catalog .