A series of high performance models that are widely used in network or single machine work environments.
Screen size: 5.7 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: QVGA (320 x 240).
Display device: STN color.
Host frame color: black.
Power type: DC24V GT1030-LBDW2-C Manual .
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment GT1030-LBDW2-C
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system GT1030-LBDW2-C Manual .
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT1030-LBDW2-C Manual . Cable length: 30m.
For connection between QnA/A/FXCPU (D-SUB25 pin connector) and GOT.
Connection between serial communication unit (AJ71QC24-R4) and GOT MITSUBISHI GT1030-LBDW2-C Gateway Functions Manual.
Applicable models: GT10, GT21. Function: the core function of the condensed display MITSUBISHI GT1030-LBDW2-C Gateway Functions Manual.
Picture size: 3.8 inches.
Resolution: 320 * 128 dot.
Display: TFT monochrome.
Panel color: black.
Power type: DC24V.
Small body equipped with ethernet!
Compared with the past, the upgrade of 320 x 128dot 4 x high resolution lcd.
HD LCD screen.
Equipped with TFT monochrome 32 gray level of high resolution liquid crystal, compact body design and display the effect is clear MITSUBISHI GT1030-LBDW2-C Gateway Functions Manual.
1, SD memory card module with the interface.
Can be installed to buy the SD memory card module, save the alarm and log data.
2, USB interface: device USB (Mini-B USB)
Can connect to the computer to transfer data.
3, RS-422/485 interface.
Can be connected to a variety of FA machines, bar code reader.
4, Ethernet interface.
Up to 2 different manufacturers can bbe connected to the FA machine GT1030-LBDW2-C .
Backlight color variety, equipment status at a glance.
The use of direct 5 color backlight, according to the production of equipment, respectively, the use of backlight color / flicker.
In addittion, the control of the backlight can be carried out by connecting the programmable controller GT1030-LBDW2-C Manual . (picture color switching, ON/OFF/ flashing backlight).