Free change detection direction.
Small, can press the front, side (15 degrees) position change detection direction.
Type: small detection variable terminal plate / DC type.
Shape: non shield.
Detection range: 15mm.
Output status: NO/NC PNP (conversion). Size: M12 (Brass); Double; Unshielded.
Sensing distance: 16 mm E2E Series Manual.
Connecting method (See note 1.): M12 Connector.
Body length: Long E2E Series
Output configuration: NPN.
Operation mode NC.
A new generation in global applications. The ultra small size, high performance and rich models.
5.5mm ultra small built-in amplifier.
Maximum detection distance 2.5mm. Workpiece shaking can also be stable detection.
Response frequency 1kHz.
Low consumption current E2E Series Manual.
Category: DC 2 wire type.
Shape: non shield.
Detection surface: above.
Detection range: 2.5mm.
Action mode: NO. Size: 96 x 96mm.
Category: power AC100 ~ 240V with.
Shell color: black.
Control output 1: output unit mode.
Control output 2: output unit mode.
Control mode: standard or heating cooling.
Auxiliary output points: 2 points.
The detection function of the broken wire and SSR fault of heater: detection function of single phase or three phase heater E2E Series Manual.
Event entry point: 2.
Transfer output: transfer output (special terminal).
Remote SP:4 to 20mA input.
Communication: RS-422.
General thermostat new high performance (high resolution, high speed, high precision input) type products OMRON E2E Series INSTRUCTION sheet.
Support simple operation, preventive maintenance.
A new type of liquid crystal, which can communicate with the front through the infrared port, is adopted,
Visual angle, contrast can be improved OMRON E2E Series INSTRUCTION sheet.
High resolution 5 bit display / can display 0.01 degrees C.
High speed sampling period 60ms.
All models complete a variety of (to the thermocouple /Pt/ analog input switching), 1 machines to support a variety of sensors OMRON E2E Series INSTRUCTION sheet.
Also supports remote SP.
Add PV/SV status display function, convenient to check the state of the thermostat (automatic / manual, RUN/STOP, alarm),
Interactive display PV/SV E2E Series .
By supporting software (Ver.4.0 CX-Thermo) to carry out a simple function (AND/OR logic and delay),
Be able to execute flexible contact output E2E Series Manual.
Increase the control output ON/OFF number counting function, can predict the temperature controller internal relay fault.
Position ratio type.