Superior high efficiency IPM motor.
Output power: 22kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MR-J2-20A Communication Function Operating Installation Guide. MR-J2M multi axis servo amplifier MR-J2-20A
Interface type: compatible with SSCNET high speed serial bus.
The servo control system is a kind of operating system which can automatically control the mechanical movement of the test device according to the predetermined requirements.
In many cases, refers to the servo system is to control the amount of (the system output) is a feedback control system of mechanical displacement or displacement velocity and acceleration,
Its function is to make the output of the mechanical displacement (or rotation angle) to accurately track the input displacement (or rotation angle) MR-J2-20A Communication Function Operating Installation Guide.
The structural composition of the servo system and other forms of feedback control systems are not distinguished in principle. Drive unit.
MITSUBISHI universal AC servo amplifier MELSERVO-J4 series MR-J2-20A Communication Function Operating Installation Guide.
Rated output: 30kw.
Interface: universal type.
Power supply: three phase AC200V.
Special specifications: full closed control 4 wire / support mechanical end encoder ABZ phase input / support positioning mode MITSUBISHI MR-J2-20A Manual.
Support position control, speed control, torque control.
Position control to follow the position instructions MITSUBISHI MR-J2-20A Manual.
When the control is inserted, the position control is performed.
Speed control follows the speed command to control the speed within a certain range.
Torque control to follow the torque command to control the stable torque.
Function of switching amplitude. The increase in the process of switching and stopping,
And in the operation of the use of the switching signal, switching growth MITSUBISHI MR-J2-20A Manual. Specification: allowed regeneration power: 300W, resistance value: 40 ohm.
Uses: MR-JE-70B, MR-JE-100B, MR-JE-70A, MR-JE-100A with. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 1.0kw.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for linear servo motor.
Power specification: three phase AC400V.
More advanced real-time automatic tuning by setting response values,
Including the position gain and the gain of speed, all the gain can be adjusted automatically.
32 segment response level can be set.
Advanced vibration suppression control.
An optimal viibration control filter value is automatically set by the automatic tuning function to effectively suppress the vibration of the 100Hz frequency that occurs when the driving part stops MR-J2-20A .
TThe automatic tuning function can effectively restrain the vibration of the end of the mechanical arm and reduce the residual vibration in the machine MR-J2-20A Communication Function Operating Installation Guide.