RS232 connector conversion cable (round connector, 9 pin D-sub connector).
Easy connection through the hub CPU.
By using an Ethernet hub, programming tools and multiple CPU can be connected simultaneously.
Through the programming tool can be searched and displayed in the list has been connected to the CPU MITSUBISHI PLC Programming Manual.
Therefore, even if the IP CPU address is unknown, just choose from this list, you can easily connect Q20UDEHCPU
Seamless communication without network level constraints.
With the latest high-speed, large capacity IE CC-Link controller network and IE CC-Link field network,
Corresponding to the increasing amount of information.
Together with previous MELSECNET/H, Ethernet and CC-Link,
These networks can be across the network type or level of differences, to achieve seamless communication MITSUBISHI PLC Programming Manual.
Programmable logic controller on the network through the programming tool of the Ethernet connection,
Monitoring and programming.3 slots.
The main substrate needs to be equipped with CPU and power supply.
Requires 1 power modules.
Used to install Q series modules.
A variety of modules with excellent performance,
Meet the needs of various control from analog to location MITSUBISHI PLC Programming Manual.
Q series module products include a variety of types of I/O, analog and positioning function module.
Can fully meet the switch, sensor, such as the input and output, temperature, weight, flow and motor, drive control,
As well as the requirements of high-precision control of the positioning of the industry, the control needs of various fields Q20UDEHCPU Programming Manual Q20UDEHCPU Programming Manual.
Can also be used in combination with the CPU module to achieve appropriate control.Input / output points: 4096 points.
Number of input and output elements: 8192.
Program capacity: 1000 K step.
Processing speed: 0.0095 s.
Program memory capacity: 4000 KB Q20UDEHCPU Programming Manual.
Support USB and network.
Support installed memory card.
Providing high speed communication between multiple CPU.
Shorten the fixed scan interrupt time, high precision device.
The minimum interval of the fixed period interrupt program is reduced to 100 s.
The high speed signal can be accurately obtained, which makes the contribution to the higher precision of the device.
High speed and high precision machine control by multi CPU.
By parallel processing of the linear and multi CPU high-speed communicatiion (cycle 0 Q20UDEHCPU Manual. 88ms) of the parallel control program, the high speed control.
Multi CPU high speed communication cycle and motion control synchronization, so it can achieve the maximization of computing efficiency.
Inn addition, the latest movement control CPU in performance is 2 times the previous model,
To ensure high speed and high accuracy of the machine control MITSUBISHI PLC Programming Manual.