MITSUBISHI inverter FR-F720 series.
Voltage level: three phase 200V.
Frequency converter capacity: 90KW.
When the ring is opened, the frequency converter is provided with a load of the motor when the motor is operated with a load at a given frequency,
The range of the motor speed in the rated slip ratio (1%~5%) changes FX2NC-16MR-T-DS Manual.
For the requirements of relatively high precision, even if the load changes are also required to operate at a given speed of the occasion,
Inverter with PG feedback function can be used (selection) FX2NC-16MR-T-DS
If the given acceleration time is too short, the output frequency of the inverter is far more than the change of the speed (electric angular frequency),
Converter will be due to flow over the current trip, the operation stopped, which is called stall FX2NC-16MR-T-DS Manual. Max input / output points: 16 points.
Power supply voltage: 24VDC.
Input points: 8 points.
Output points: 8 points.
Output type: relay.
Power consumption: 20W.
Weight (kg):0.6.
Size (WxHxD) mm:130x90x87.
Note recording function, Component annotation can be recorded in the program register.
Online program editor, online change the program will not lose the working hours or stop production operation FX2NC-16MR-T-DS Manual.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to protect your program MITSUBISHI FX2NC-16MR-T-DS HARDWARE MANUAL.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard MITSUBISHI FX2NC-16MR-T-DS HARDWARE MANUAL.
Continuous scanning function, to define the operation cycle for the application of the continuous scan time.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017). Axis of control: 1.
Interpolation: No MITSUBISHI FX2NC-16MR-T-DS HARDWARE MANUAL.
Program memory: built-in 3.8k step EEPROM.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
Not only can deal with single speed positioning and positioning,
Can also carry on the multi section fast operation and so on complex control.
Can not be connected to the PLC, while running alone.
1 can control 1 axes,
FX1N, FX2N, PLC FX3U up to 8 units can be connected,
PLC FX2NC up to 4 units can be connected,
FX3UC PLC can connect up to 7 units, and a plurality of shafts can be independently controlled FX2NC-16MR-T-DS .
Can output up to 200kHz of the pulse train.
The connection function of thhe absolute position detection function and the manual pulse generator FX2NC-16MR-T-DS Manual.
Can be used in the form of flow chart programming software, visual programming.