ASCII Unit
This program runs independently from the ladder-diagram program in the PLC.

Name: ASCII Module.
Model: C200H-ASC11.
Communications port>Port 1: RS-232C(peripheral device or termi-nal connection).
Communications port>Port 2: RS-232C(peripheral deviModel : CVM1D-BC051.
5-slot.Protector for Expansion I/O Rack IOIF connector CV500-COV02Type: Counter inputs, pulse outputs CPM1A-40CDT-A-V1 CPM1A-40CDT-A-V1
12 DC inputs: Yes.
Counter inputs: 2.
Analog inputs: None.
8 transistor outputs: Yes.
2 pulse outputs: Yes.
2 analog outputs: No.Model: C200HW-COM01.
Specifications: Communications port for Controller Link, SYSMAC LINK Units.C200HW Communications Interface Module C200HW-PRM21Name: Three-tier Screw Terminal Block.
Specifications: Outputs; 8 outputs; PNP;
Without Short-circuit and,
Disconnected Line Detection CPM1A-40CDT-A-V1 .
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site CPM1A-40CDT-A-V1 .
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. Name: Three-tier Screw Terminal Block.
Specifications: Inputs; 16 inputs; NPN;
With Short-circuit and,
Disconnected Line Detection.
"Easy" and "Flexible" system expansion,
with linked CC-Link and CompoNet.
Branching is easily made with CompoNet.
Wiring material cost can be reduced.
Bit-level I/O distribution reduces,
wiring in the system.
A wide variety of CompoNet Slave Units,
contribute to system size reduction.
Seven-segment Display on the Gateway Unit,
helps to detect errors on site.
The Participation Flags and Communications,
Error Flags can be checked at the Host,
Controller to detect the location and,
content of the error. Unit classification: CJ1 CPU Bus Units.
Product name: Motion Control Unit with,
MECHA TROLINK-II interface.
Specifications: Control modes : Position,
speed, or torque control via MECHATROLINK-II,
Control axes : 32 axes max. (30 physical axes,
2 virtua axes).
Internal programming language: Special motion contro
language
No. of unit numbers allocated: 1 CPM1A-40CDT-A-V1 I/O Wiring Diagram.
Current consumption: 5V, 0.60A; 24V, --.
Standards: UC1, CE.
Improve Equipment Design Efficiency,
and Shorten Tact Time.
Control Servos for up to 16 axes in,
a motion networkk with one Position,
Control Unit that supports MECHATROLINK-II CPM1A-40CDT-A-V1 I/O Wiring Diagram.
MECHATROLINK-II is a registered trademark,
of the MECHATROLINK Members Association.