MES interface module.
Need MX MESInterface software and CF card.
Easily connect production equipment and information system.
Through the excellent database sharing function, greatly reduce the cost of information.
By direct connection, the connection process of the enterprise system database (such as MES) is simplified QCPU-A (A Mode)  Programming Manual.
Module configuration is simple, without any programming QCPU-A (A Mode) 
The data can be monitored in the module side, when a user defined trigger condition occurs,
Will be read in the form of SQL text and send the specified data to the MES.
The network load can be reduced compared with the previous scheme which is based on the gateway PC to obtain / monitor the data.
Receive information from the MES, perform pre stored SQL tasks QCPU-A (A Mode)  Programming Manual.
In addition, the production instructions from the MES are also received,
The production information can be downloaded from the database, and the modification of the formula information can be conveniently carried out. Upgraded version.
Control axis: maximum 32 axes.
Manual pulse generator operation function: can use 3 sets of manual pulse generator.
Synchronous encoder operation function: can use 12 synchronous encoder QCPU-A (A Mode)  Programming Manual.
Peripheral I/F: by CPU PLC.
High speed motion control system based on multi CPU architecture.
Multi CPU system based on Q series PLC.
Flexible selection of CPU PLC and motion CPU according to different applications.
In the construction of multi CPU system, can have up to 4 sets of CPU.
When 3 Q173DCPU is used, the maximum 96 axes can be controlled.Three-phase 3 wire type.
Measuring circuit number: 4 circuits.
Measurement items: power consumption (consumption, regeneration), current, voltage, power, power factor, etc..
Power measurement module product group capable of simply measuring various energy information.
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information.
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm.
Only in the ON state can be used to measure the output of the output device.
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment.
3 phase 3 wire products can be used to measure up tto 4 circuits in one slot,
3 phase 4 wire products can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products QCPU-A (A Mode)  Manual .
For example, a module ccan be used to measure other loads from the control panel trunk QCPU-A (A Mode)  Manual .
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.