Cable length: 20m.
For connection between QnA/A/FXCPU (D-SUB25 pin connector) and GOT.
Connection between serial communication unit (AJ71QC24-R4) and GOT.
Applicable models: GT10, GT21. Cable length: 10 meters.
FXCPU GOT.
FXCPU communication function expansion board GOT.
[MINI-DIN 8 pin loose line (row 5 pin interface terminal)] GT2508-VTWD-GF Connection Manual.
Applicable model: GT21. USB slave station (PictBridge), 1 channel for printer connection GT2508-VTWD-GF
Applicable models: GT16, GT15, GT27, GT25. Cable length: 5m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT. Optical fiber loop unit.
Applicable models: GT15, GT16, GT27, GT25. Cable length: 10m.
For connection between FXCPU (MINI-DIN8 pin connector) and GOT GT2508-VTWD-GF Connection Manual.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
Applicable models: GT10, GT21. For GT1675-VNB / /GT1672-VNB.
Applicable model: GT16. "RS-422/485 serial communication unit (terminal unit).
When the temperature controller is connected to the temperature controller through the RS-485 or the GOT multi point connection, the controller can be used GT2508-VTWD-GF Connection Manual.
Applicable models: GT15, GT16, GT27, GT25. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 12.1 inches.
Display color: 256 color or more color.
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrrated to the touch screen system GT2508-VTWD-GF Manual .
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT2508-VTWD-GF Manual .