Input points: 36 points.
Output points: 24 points.
Power supply voltage: AC240-360V.
Output type: transistor output (source).
Built in CPU, power supply, input and output. While maintaining the convenience of FX1N while improving performance.
Special adaptor and function expansion board can be installed and used FX3 series FX2N-48MR-DS PROGRAMMING MANUAL II.
High speed operation.
Basic instructions: 0 FX2N-48MR-DS21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. Function: CPU module (internal service power supply).
Input and output points: 32 points.
Power supply capacity (DC5V power): 1100mA.
Power supply capacity (DC24V service power supply): 600mA FX2N-48MR-DS PROGRAMMING MANUAL II.
Input / output mode: DC input (drain / source) / transistor (source).
Input points: 32 points.
Output points: 32 points.
The new expansion module is more convenient!
Pioneer products with advanced built-in functions and rich extensibility.
FX5U built-in analog, communication, high speed input and output,
By extending the board and adapter can be easily extended system FX2N-48MR-DS PROGRAMMING MANUAL II.
In addition, through the high speed system bus,
Can maximize the role of the built-in intelligent functions of the expansion device.
Convert connector to screw relay terminal.
The action of the signal of the conversion module is shown in the light of the lamp.
Negative common end with display. Axis of control: 1.
Interpolation: No.
Program memory: built-in 3.8k step EEPROM.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
Not only can deal with single speed positioning and positioning,
Can also carry on the multi section fast operation and so on complex control.
Can not be connected to the PLC, while running alone.
1 can control 1 axes,
FX1N, FX2N, PLC FX3U up to 8 units ccan be connected,
PLC FX2NC up to 4 units can be connected,
FX3UC PLC can connect up to 7 units, and a plurality of shafts can be independently controlled FX2N-48MR-DS Manual.
Can output up to 200kHz of the pulse train.
The connection function of thhe absolute position detection function and the manual pulse generator FX2N-48MR-DS Manual.
Can be used in the form of flow chart programming software, visual programming.