20 pin connector on both ends of the circular multi-core cable.
Length 1.5M. Needle number: 20.
Specification: Cable flat cable connector, supporting 10 sets. Application: you can transfer the same image data at a high speed (about two seconds per 64KB data) to multiple F940GOT.
When programming software is used in the case of Designer2 GT,
You can create a file in HEX Intel format FR-ABR-H0.4K Instruction manual FR-ABR-H0.4K
Using communication software to transfer data to a ROM writer.
Application Series: F940GOT. Application: a write device (with a built-in flash memory) that is not required to use a similar ROM writer,
GOT can be carried out between the fast and simple picture data transmission.
Application Series: F940WGOT, F940GOT FR-ABR-H0.4K Instruction manual. Max input / output points: 128 points.
Power supply voltage: DC24V.
Input points: 64 points.
Output points: 64 points.
Output type: transistor.
Power consumption: 100VA.
Weight (kg):1.8.
Size (WxHxD) mm:350x90x87.
Since the FX2n series have the following features: the maximum range of inclusive of the standard features, program execution faster, the full complement of communication function, suitable for different countries in the world, and the power to meet a large number of special function modules of individual needs,
It can provide maximum flexibility and control capability for your factory automation applications FR-ABR-H0.4K Instruction manual MITSUBISHI FR-ABR-H0.4K Manual .
Control 16~256 point.
Built in 8K capacity of the RAM memory, the maximum can be extended to 16K.
CPU arithmetic processing speed of 0 MITSUBISHI FR-ABR-H0.4K Manual . 08 S/ basic instructions.
On the right side of the FX2N series can be connected to the input and output expansion modules and special function modules.
The basic unit is built in the 2 axis independent maximum 20kHz positioning function (transistor output type).
Quick disconnect the terminal block, which adopts excellent maintainability to quickly disconnect the terminal blocks, even if the cable is then replaced by the cable MITSUBISHI FR-ABR-H0.4K Manual . MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V.
Power: 1.5kw.
SLD converter rated current: 10.5A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight).
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FR-A7000 series, to reduce the volume of equipment) FR-ABR-H0.4K .
For applications that require high torque at low speeds, the HD rating is the most suitable.
The controller is used to control and monitor the frequency converter through the network FR-ABR-H0.4K Instruction manual.
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps.