Master station module for CC-Link/LT.
I/O control can be used in the province of CC-LINK/LT.
Is to make PLC CC-LINK/LT as the main station of the FX system module.
The master station module and the remote I/O module can be connected by a special connector, and achieve the purpose of the distribution of the province MITSUBISHI PLC HARDWARE MANUAL.
Up to 64 remote I/O station modules can be connected FX3UC-32MT/D
Remote I/O module is assigned a common X, Y soft components,
By using the same procedure as the common input and output.
Even if the use of 2 points, 4 points of the remote I/O module, the number of soft components can be continuously assigned,
So it can be efficiently allocated I/O. Total points: 30 points.
Input points: 16 points MITSUBISHI PLC HARDWARE MANUAL.
Output points: 14 points.
Voltage: AC220V.
Output type: transistor.
Outline dimension: 100*75*90.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment MITSUBISHI PLC HARDWARE MANUAL. The frequency of a transducer can be set by a digital signal from an external BCD or binary code.
BCD code 3 (maximum 999).
BCD code 4 (maximum 9999).
Binary code 12 (max FFFH) FX3UC-32MT/D HARDWARE MANUAL.
Binary code 16 (max FFFFH). MITSUBISHI inverter FR-A740 series.
Voltage level: 3 phase 400V.
Frequency converter capacity: 30KW FX3UC-32MT/D HARDWARE MANUAL.
FR-A700 converter products are suitable for all kinds of high load requirements of the equipment.
Such as lifting, lift, printing and dyeing, printing and dyeing, material coiling and other general occasions.
High level driving performance.
Unique sensorless vector control mode,
A wide variety of mechanical equipment can be operated at high precision in the super low speed region without the need of the encoder FX3UC-32MT/D HARDWARE MANUAL.
With torque control mode,
And in the speed control mode can use the torque limit function.
With vector control function (with encoder),
Frequency converter can achieve position control and fast response, high precision speed control (zero speed control, servo lock, etc.) and torque control FX3UC-32MT/D Manual. Power: 3.7kw.
Voltage: 200V.
Purpose: high frequency braking resistor.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor.
Can also be connectedd without built-in brake transistor inverter MITSUBISHI PLC HARDWARE MANUAL.
Three types of discharge resistors are available.
Please select according to the required braking torque.